2020 Forest River Salem FSX Travel Trailer Blind Spot Detection

Hello Nick, thanks for reaching out. When replacing your equalizer, the replacement must be identical in size to the stock equalizer. There is a small amount of wiggle room, like 1/2" or less, but any more than this can throw your suspension out…

If you are looking for a suspension lift for your Forest River Wildwood X-Lite 273QBXL due to its low ride height the best option is absolutely the Dexter Trailer Springs Over-Under Conversion Kit #K71-384-00. The reason is this will give you the…

Hey Bryan, I would go with the Kenda Karrier KR53 part #KE72EV to use as a spare on your 2012 Jayco Jay Flight travel trailer. Its the correct size wheel and tire that you need, it's the Load Range D you need, and also is the best priced option…

Hey Rich, The B&W Patriot 5th Wheel Trailer Hitch #BWRVK3200 weighs 143.7lbs and the B&W Custom Installation Kit w/ Base Rails #BWRVK2500 weighs 79.11lbs. If you're concerned about the amount of weight on the rear axle we can look into…

Hey Jeffrey, There isn't a guide to tell us what your motorhome has installed on it but you can remove the shroud on the rooftop unit to look for the manufacturer sticker that lists the model number and BTU rating. You'll also need to remove…

Hello Tim. We can definitely set you up with a complete AC system with an Advent low profile unit. We currently do not offer these parts as a package, but you can purchase all of the exact same components separately. To answer your question, yes, the…

The number you mentioned corresponds with a Lippert Ground Control 2.0 so for a control module replacement you would want the part #LC242623.

Your trailer looks awesome! The Road armor equalizers #LC696740 and Equa-Flex Cushioned Equalizers #LC279687 are both pretty similar in performance even though the Road Armor has two dampers. The main difference is the size of the equalizers. The…

I believe that on your 1 inch flat surface, you could mount the Hopkins Cross-Check Trailer Level, #HM09615. The overall width is 1-1/2 inches but the mounting holes are just close enough to where it should work on your 1 inch flat surface. Out of…

Upgraded equalizers are a great way to improve the ride of your trailer. In order to choose the correct replacement you will need to measure your current equalizer. The best upgraded equalizer is the one that matches your current equalizer…

According to Lippert, the correct bearing kit is the #BK3-200. This includes the #14125A outer and #25580 inner bearing, along with the 10-36 grease seal.

Hello Bob, thanks for reaching out. Unfortunately there is not a camera available that is compatible with the Voyager WVOS54 monitor. This is an older first gen camera system and they have been discontinued so we do not have a compatible camera. The…