Rain Guards Specs:
Features:
Reduce in-cabin wind noise and air turbulence with this tinted rain guard for your vehicle's sunroof.
More Information >Videos
for Rain Guards
Help Articles
for Rain Guards
Expert Answers
for Rain Guards
The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…
view full answer...Hey Adam, yes the B and W hitch part #BW47BR that you referenced is a confirmed fit for your 2025 Toyota RAV4 plug in hybrid. What are you planning on using the hitch for?
view full answer...Hey Randy! For the OEM prep package you'll need to reach out to a Ram dealer, but I can help you out with an underbed system for your 2026 Ram 2500 if you aren't dead-set on getting the exact same as the OEM. The closest we have for your…
view full answer...Hi Tom! I included a link to the instructions for the B&W Trailer Hitch Receiver - Custom Fit - Class III - 2" #BW47BR that will fit your 2024 Toyota RAV4 Hybrid. We haven't installed one of these in house quite yet, so no install video,…
view full answer...Hi David; the Timbren Rear Suspension Enhancement System #TDR1500DS is not available with a lower capacity. All of the Timbren SES bump stops come with a high capacity like these. If 1,500 lbs is enough the SumoSprings Solo Custom Helper Springs…
view full answer...A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…
view full answer...Hello Derick, thanks for reaching out. The only way to know if the Curt Helux Shock-Absorbing 5th Wheel Pin Box #C73RJ will work for you is to determine what pin box you have currently. The best way to do this is to find the sticker on the pin box…
view full answer...Hi Duane; the AeroTread Running Boards #AA2061031 fit the 2025 Durango if you do not have OE side skirts. I believe the R/T comes with the side skirts so they would not fit. For running boards that will fit with the side skirts I recommend the Aries…
view full answer...You can use the QM3 mounting hardware #TH04997 for the Weekender rooftop cargo box. This will use the carriage bolts as you stated and will fit 4 inch on center holes. I've attached some photos and a video to assist.
view full answer...Hey Ryan. The lack of trimming on the B&W Trailer Hitch item #BW82PR compared to the etrailer item #e45ZR does come with a bit of a trade off. The receiver for the B&W item #BW82PR sits lower when installed on your 2025 Kia Telluride…
view full answer...Good question! Can you close the hatch of the vehicle the CVT Timber Creek Annex #RG35ZV is attached to? Yes. However, it should be noted that the hatch is actually acting as a roof support, so some of the roof will not necessarily cave in, but it…
view full answer...Hey Satran. The tallest 5th wheel hitch we have with a 30,000 lbs capacity is the Reese M5 item #RP68FR. This fits the Ford factory puck system and has three adjustable heights of 14", 16", and 18". The B&W Companion OEM 5th Wheel…
view full answer...