To see if this custom-fit item will work for you please tell us what vehicle you'll use it with.
Thank you! Your comment has been submitted successfully. You should be able to view your question/comment here within a few days.
Error submitting comment. Please try again momentarily.
When you need a cover that works as hard as your truck, the Revolver X2 steps up with heavy-duty materials built for strength and endurance. The 1/4" thick, aircraft-grade aluminum slats are covered in textured black vinyl for a clean look and solid defense against impacts, UV rays, and bad weather. It’s strong enough to hold up to 400 lbs of evenly distributed weight when rolled out, so you can trust it to protect your gear from whatever’s on the road ahead.

Big loads shouldn’t mean losing your cover. The hybrid roll-up design gives you complete access to the bed in seconds. Just release the latch with one of the corner cords, roll the cover forward, and lock it in place behind the cab with the built-in nylon straps. You don’t have to remove anything, and since it mounts inside the bed rails, you still have full use of your stake pockets for tie-downs or accessories.




Some covers sit high and bulky over the rails, but this one stays clean and almost level with them. The ultra-flush fit keeps your truck’s lines smooth while cutting down wind drag for better aerodynamics. The matte black finish blends naturally with trim and bed caps for a simple, tight look that doesn’t block visibility or add bulk.

When the tailgate is closed and locked, so is your bed. The Revolver X2 uses rotating side rails that clamp down on each aluminum slat as the rear section latches shut. Reinforced locking levers at the tailgate hold everything tight from front to back without Velcro or snaps. This design keeps your cargo safe from prying fingers while staying easy to open when you need it.



Getting it on your truck doesn’t require special tools or drilling. The frame rails clamp inside the bed rails using included mounting plates and bolts that line up with pre-set slots for proper alignment. Once tightened down, the cover fits square every time without trial-and-error adjustments—ready for daily use right out of the box.





Ratings & Reviews

Bob B.
11/21/2017
Still water resistant, works well, and looks great

Keith C.
3/12/2017
Hi Laura - I am still pleased with my BAK bed cover. I dont like it quite as well as the previous version I had on my other 2013 Nissan Frontier truck which got stolen, hence the new cover, but I am still pleased with the product. The new cover doesnt roll or latch quite as smoothly as the old one, but it still works well. They also slightly changed the clips for anchoring the rolled up cover, and I find them harder to clip in and maintain tension on the strap, but again they do work. Thanks for following up.

Sean M.
4/12/2020
Its still holding up well and it looks as good as it did the day I installed it. I have no regrets about making this purchase.

Kyle R.
5/22/2020
My judgment has not changed. This cover is still excellent. If I ever get a different truck, this will be among my first accessory purchases.

Matt
11/22/2021
Couldnt be happier! Great quality product!

Jenny N.
7/17/2023
I am sorry to hear that this cover is not working out for you. Would you be able to send a picture of where the vinyl is separating from the aluminum?
Do you have a question about this Tonneau Cover?
Info for this part was:
At etrailer we provide the best information available about the products we sell. We take the quality of our information seriously so that you can get the right part the first time. Let us know if anything is missing or if you have any questions.












Martin H.
3/4/2020
Well, not so happy with the product. The carpeting fell off on the underside of the cover. Also the right side of the cover towards the tailgate shrank. Its been a few months since I started to have those issues and should of contacted you earlier for warranty. Hopefully its not too late for a warranty claim.