Converter and smart charger helps extend the life of your RV battery by fighting sulfation during storage. Multistage charging process switches modes to ensure a quick, full charge. Converts AC shore power to DC to run 12V loads.
Features:
Specs:
Replacement Cross-Reference:
Note: Not all units are a direct replacement. Modifications may be required.
This smart converter charger converts AC shore power into DC power and uses the Charge Wizard multistage charging system to charge your battery bank. If your RV already has a stock converter charger, it will need to be removed to ensure this unit operates properly.
Using the built-in Charge Wizard, the converter charger automatically switches voltages while the battery bank charges. This accelerates the charge, but also helps extend battery life by adjusting the voltage during the different modes. This charger is compatible with flooded lead acid, AGM, and gel batteries.
Charging Modes
The system includes a number of safety features. It has a reverse polarity protection that will protect the converter if the battery is hooked up incorrectly. Additionally, the unit includes protection for overvoltage, undervoltage, and overcurrent, which can damage your equipment, as well as the converter. It also has GFCI protection that shuts off power when there is a current imbalance. The built-in cooling fan also removes excess heat from the unit. The fan speed is proportional to the internal temperature on the converter, so when the power demand is low, the fan will operate quietly.
The Converter Status Remote Pendant (sold separately) monitors the converter's charging status. It also allows you to manually override the charge process to verify the unit is operating properly. The pendant uses a flashing green LED to indicate what charging mode is active. It easily connects to the converter's accessory port with the attached cable.
The converter mounts horizontally inside your RV in a dry location with ventilation. However, as long as the unit has sufficient ventilation, it can also be mounted vertically. The mounting hardware is not included.
The DC output terminals wire to the battery bank. The AC in cord plugs into a 120V 3-wire grounded source.
California residents: click here
Videos are provided as a guide only. Refer to manufacturer installation instructions and specs for complete information.
Today we're going to take a look at the Progressive Dynamics PD 9200 series, 12 volt, 45 AMP, and tele-power converter. This 9200 series power converter is designed to provide reliable powered DC power to all of the recreational vehicles 12 volt lighting and applying circuits. It also provides safe and rapid recharging of the RV battery.The built in features on this ensure long-term reliability and those features are electronic current limiting, which will automatically reduce the output voltage, prevent overheating. Also, it has reverse battery protection which will prevent the charger any damage if the connections are accidentally reversed, and also, high-voltage and low-voltage protection to prevent damage from AC input voltage fluctuations.Also, it offers automatic thermal protection. It protects from damage due to excessive heat. This also includes the built in charge wizard, which is a microprocessor controlled system that constantly monitors the batter voltage and ensures a rapid, yet safe recharge.
Now, this charge wizard can select one of three charging voltages and one of four operating modes depending on the condition and use of the battery.The three charging voltages it uses is 14.4 volts, 13.6 volts, and 13.2 volts. The four operating modes it offers is boost, normal, storage, and desofation. Also, if you notice in the very front, right here, it has a built in accessory port. It makes it very easy to the converter status remote pendant that'll show you which mode the converter is operating in. It does offer variable speed intelligent cooling fan right over here.
This will only operate under high heat conditions. It is GFCI protected. Helps prevent ground fault interruption. It's UL listed, and this part is assembled in the U.S.A.Now, to go over a few specs on this. The input voltage is 105-130 volts AC.
Wattage is 725 watts. Output voltage, 13.6 volts DC. Power draw is 45 AMPS. The operating temperature for this unit is zero degrees Fahrenheit to 120 degrees Fahrenheit. The storage temperature is negative four degrees Fahrenheit to 176 degrees Fahrenheit.
A few measurements on this. The overall length we'll measure from this part, all the way to here. So, you're looking right at eight and a quarter inches long. Total width on this, if we flip it up, we're going to measure mounting bracket to mounting bracket, is right at seven and a quarter inches wide. The total depth of this unit is going to be right at, here we go, four and eleven sixteenth inches deep. The power cord is about 30 inches long and the weight on this unit is about four point five pounds.That should do it for the review on the Progressive Dynamics PD 9200 series, 12 volt, 45 AMP, and tele-power converter.
Average Customer Rating: 5.0 out of 5 stars (1 Customer Reviews)
Converter and smart charger helps extend the life of your RV battery by fighting sulfation during storage. Multistage charging process switches modes to ensure a quick, full charge. Converts AC shore power to DC to run 12V loads.Actually didn't need the product. But keeping it as a spare. Shipping was as noted. 737452
Do you have a question about this RV Converter?
Info for this part was:
At etrailer.com we provide the best information available about the products we sell. We take the quality of our information seriously so that you can get the right part the first time. Let us know if anything is missing or if you have any questions.
Thank you! Your comment has been submitted successfully. You should be able to view your question/comment here within a few days.
Error submitting comment. Please try again momentarily.