Round tubing leaves flat tie-down anchors with poor mounting contact. This contoured E-track anchor welds to curved steel surfaces from 3/4" to 2" in diameter, adding a low-profile 1,000-lb WLL attachment point to racks or custom tubing.
Flat anchors aren't a natural match for curved tubing on ladder racks, van racks, or custom trailer fabrication. This contoured anchor welds directly to curved metal, with its best contact on steel tubes from 3/4" to 2" in diameter. Your round-tube structure gains a permanent E-track attachment point exactly where you weld it.
Sometimes you only need a tie-down point in one specific spot. The single-slot anchor sits 1/2" tall off the surface and accepts Snap-Loc cargo straps, ring attachments, and E-track accessories (sold separately). You get an isolated attachment point that stays low when there's nothing connected to it.
Tie-down anchors must be chosen according to their safe working load limit (WLL). The weight of the secured cargo must not exceed the combined WLL of the anchors being used. For example, if you are using anchors with a WLL of 100 lbs each to tie down a load weighing 400 lbs, then you need at least 4 anchors to safely secure that load. It is recommended that you always use anchors in pairs.
Info for this part was:
At etrailer we provide the best information available about the products we sell. We take the quality of our information seriously so that you can get the right part the first time. Let us know if anything is missing or if you have any questions.
Thank you! Your comment has been submitted successfully. You should be able to view your question/comment here within a few days.
Error submitting comment. Please try again momentarily.