Best Forest River Wildwood X-Lite Travel Trailer Camper Jacks

One of the best additions to our 5th wheel yet! I added these myself and it was not too hard, but I do have the proper tools. One install issue was around the pushout where I had to modify a bracket(see photos) We did a coast to coast and stayed in a LOT of places. These jacks worked very well as long as I got reasonably level side to side first. A few inches out is fine so most spots were a breeze, a few I needed to be on blocks so the tires did not come off the ground. The phone app is great to see initial level from the drivers seat, but I did most final leveling from the control pad. Overall great product and I recommend them especially if you are setting and breaking camp a lot.

shipped in a timely manner. Easy install wit good instructions. I did have one question about the location of the rear lifts and called the company and we had an answer instantly. Wiring was very easy with good instructions. The system worked on the first try and have had no issues so far. Great system. I was looking at newer campers with auto leveling and about 40 to $50,ooo if I traded my paid for camper in. The cost saved me a lot of money and works as it should and saves my back and a lot of set up time. would and have recommended to others. Thanks.

if I had to rate this upgrade in difficulty one being the easiest five being the hardest, it would be a one. Super simple. Take the nuts and bolts off your old hardware and install the upgrade in its place. I read some of the reviews were people were annoyed with the counter clockwise rotation and the bolt sticking out too far. I really didn’t see a problem with either. I know you’re not supposed to use a drill to extend and retract these but I always have. I suppose as long as you’re not torquing the heck out of the adjustment screw you shouldn’t have any problems. I always put a small flat 2 x 6 piece of wood under the foot of each one of these. It seems to add quite a bit of stability.

The jacks themselves have worked great, they keep the trailer level and solid during our concession events. I just had them mounted to the trailer so I don't have to put them in and out at each event. The jack handles leave a bit to be desired so I use a 20v drill w/ a 3/4" socket to run them up and down.

The powerhead is very large and extends forward, which has caused it to impact upon two different vehicles when backing the trailer. The power function is now useless, and I am using the manual crank to raise and lower the jack.

Sturdy jack, easy to install. We installed it facing to the driver's side so we can still put our tailgate down. Very powerful jack, only drawback is it is very slow.

Works great as a stabilizer. I have a 38' trailer and I use screw jacks to level the trailer. Once the trailer is level I lower the stabilizer jacks to eliminate any movement. With this combination the trailer does not move one bit.

There's not a lot to say. The first Stabilizer carton was damaged to the point the carrier couldn't even find the Stabilizer. etrailer.com was very cooperative & sent a second unit out right away. Although the second shipment packaging was damaged all parts were there and undamaged. I installed the unit and it is so so much better, quieter and faster than the old unit. I highly recommend both Lippert and etrailer.com

After receiving the packages was very severely damaged and there was no Jack.Stand crank and no nuts and bolts.Don't know what else I miss

I bought 2 sets of these to level & stabilize a 7500lb smoker trailer (1 in each corner). though they do stabilize, They don't lift to level it off (meaning by inches), the weight/load rating paired with the word "Jack" is misleading. I had to use other "Jacks" to Level it first. This trailer is stays mostly on the pad I built for it on my property, and they work well once situated.

My Jack arrived DOA. After installing it on my trailer, the Jack didn’t work. The manual crank handle came in handy because I didn’t have time to troubleshoot and repair it at the time. It was just a wire that was no longer connected to the switch but I have to tell you it was extremely disappointing to receive a brand new item that didn’t work. If it had worked out of the box, I’d give it a five star review. You should consider soldering and heat shrinking the wires to the switches or making the wires longer so they aren’t banjo string tight and putting the lug at a strange angle.

This particular jack fit my 2001 Horse trailer perfectly. I had it installed in about 2 hours due to clearances on this particular type of Tonge design. Otherwise with a couple box end wrenches and a hydraulic bottle jack this jack could be installed in 30 minutes. It appears to be a very good product for the money. Also, it has plenty of lift capacity. 8000 pounds which is perfect for my trailer.

These things make a great trailer jack. A plate on top and your done. Tried bottle jacks, these are great.

Great replacement

One small part was missing from my Ground Control TT. Carol Korren expedited delivery of the missing part and the UPS truck pulled up at the moment I needed the part. Fantastic customer service!

This works great and has been the very best upgrade on any RV/Trailer I have every owned. I will never own another trailer that does not have this.

Work great and good backup to electrical Jack. Our electricals were not working but now are. Hopefully, they remain as backup as have to handcraft or additional support.

The jacks were well packaged and shipped out fast. I got these to replace tho ones on my camper and they bolted right up.

I should have got one years ago. I only use it when it's connected to the truck with the engine running. This I believe gives me full power. It has enough power to raise the trailer when connected to the truck to get the anti sway bars attached. Sure beats all that hand cranking.

I was amazed at how quickly my replacement from etrailer arrived. I was a bit worried that the installation of my new jack would be more difficult that I expected. The reverse proved to be the case, it was very simple to place the trailer tongue on jack stands, remove the old jack and install the new one. As the old saying goes "even a cave man could do it."

Very happy with this powered jack. I will definitely be buying a second one for my other trailer. Installation was very easy and straight forward.

Easy install, able to mount sideways so I can open my tailgate now.

I mounted this Stabilizers Jacks to the back of a 4x8 utility trailer. I use the trailer to haul my Honda ATV to MotoAmerica motorcycle races. Once the ATV is removed I lower the jacks and mount my tent inside the trailer. These stabilizers allow me to safely move around in the tent without fear of the trailer tipping.

Does not ratchet up, a pin must be manually inserted. It only came with one 6" long pin, which needs to be cut in half to make these stands functional. This is more like a folding jack stand, but the pin is not connected to the stand with a lanyard. I will be cutting the bar in half and welding a washer to hold it in place. I will also need to add a lanyard to it so I don't loose it. I would not recommend this product, but I have not found a better substitute for my application.