Summer Starts Here - Save up to 70%
# 1
Hitch Adapter 1-1/4" to 2" Trailer Hitch Receiver
It is what I ordered. Thank you. I have sent photos previously. I thought I was going to get Free Shipping as per your flashing banner. Did not. Bill Beaver
Very heavy duty. Will use it with a bike rack I had for another vehicle that had a 2" receiver.
# 2
Hitch Adapter 1-1/4" to 2" Trailer Hitch Receiver with 5" Rise
I received my trailer hitch adapter today on time as promised. I tried it out on both cars ( 2009 hyundai elantra and 2013 hyundai sonota . It works well by clearing the bumpers and raising the hitch 4 or 5 inches that i was trying to accomplish. I use the hitch for a bike rack and it was too low to the ground.My hitch is a 1-1/4 that the HT5R converts to a 2 inch but my bike rack also had an adapter to 2 inch, so it works perfect. I had talked to customer service prior to buying and they steered me in the correct direction and i am pleased to solve this problem.
Thank you for the personal touch on the order. Not many company's do this. This is a good product and a good price. My car sits low and we needed to raise the carrier up. Looks like this will work out.
# 3
Hitch Reducer 2" to 1-1/4" Trailer Hitch Receiver
This has worked great to reduce my 2" hitch so that I can continue to use my 1 1/4" Thule bike rack, and I like that it doesn't extend out much from the hitch. After my last trip though, the inset separated from the larger piece. I can still use it, but without the smaller piece fixed in place, I can't put it on the car first and then slide the bike rack into it since the smaller piece slides, and it's impossible to line the holes up. It's also rusted more than I expected. It wasn't inexpensive, and I was hoping it would last longer. I've used it for maybe a dozen trips.
Perfect fit BUT the inner tube broke away from the outer tube after about a dozen trips. One small weld on the outside corner is all that holds it on. The small amount of play must have been too much for it. I was even using an anti-rattle lock pin. Very disappointing due to the price point. And now it’s unsafe to use as it could slip right out of the receiver.
# 4
Roadmaster Dual Hitch Receiver Adapter with 2" or 6" Drop/Rise
Worked out great for my family bike adventure. Traveled with that setup over 1000 miles and it was easy drive. I had cargo carrier on the bottom and bike rack on top, and with that setup and 4 people on board still plenty of ground clearance 11". Dual hitch is a solid piece of steel that can carry a lot of lbs. Just don't overload max. tong weight, need some room for safety!
This adapter design was exactly what I was looking for. I often carry 4 or more bikes with my Sylvan GO. The pictures show how I configured my setup. Its perfect!!! And yes, I have to be a little careful on really tight turns but its never been an issue. Thank you George and the etrailer team.
# 5
CR Brophy Hitch Extender for 1-1/4" Hitch Receivers - 5-3/4" Long
Here in Saskatoon, Canada, I am very pleased to endorse J&J's flagpole holder and hitch mount extension products. Solid construction and beautifully finished engineered pieces. Fitted easily onto my '92 Camaro RS, for Shriner parades. Supporting a worthy philanthropic effort for children.
I personally couldn't use it. But I know metal industry very well and this will work perfectly in its environment. It was just not needed and I never put it on.
# 6
Curt Trailer Hitch Receiver Adapter - 1-1/4" (Class II) to 2" - 6" Long
The Curt C45785 1.25 inch to 2 inch hitch adapter seems well-constructed, but does NOT fit the current SPA Volvo OEM 1.25 inch automatic retractable hitch receptacle (mine is on a 2020 V60 Cross country). The lock pin hole doesn't go back far enough to accommodate the pin -- see photo.
Great product from an even greater company. ETRAILER has the knowledge and products to solve most any trailering problem.
# 7
Hitch Extender For 2" Trailer Hitch Receiver 7"
Allows me to use my back rack and small boat trailer without having to remove the spare tire on my Jeep Wrangler. Works well.
I needed my bike to clear my bumper on a front hitch and this did the trick. This extender is hollow so I was able to use anti rattle/ lock before adding bike rack.
# 8
Brophy Hitch Extender with Step - 2" Hitches - 18" Long - 6-1/2" x 17" Platform
I recently bought a truck tent that sets up over the open tailgate. I have a bump/step that became totally useless as it was covered by the tailgate. Then I came across the ST18 extension. Now after the tent is set up, I install the extension then the bump/step itself and your able to step up and into the tent with no problems, and it's also extremely stable!
This is exactly what I needed. Being a long time RV owner, I have purchased many items from E-trailer and have never had a bad experience. Great service, product exactly as described.
# 9
Roadmaster Dual Hitch Receiver Adapter, 2 " or 8" Drop/Rise
Perfect for my application.
Everything was delivered fast and in perfect condition.
# 10
Roadmaster Dual Hitch Receiver Adapter for Tow Bars - 2" Hitches - 2-1/4" Rise/Drop
Beefy. I have no doubts of the capacity of either side of this hitch adapter, there's plenty of weld to hold it all together. Very few options will provide minimal drop (for an off-road trailer) and minimal rise on the other side for an additional bike rack or cargo carrier. Jeeps are tough since you need to be able to open the gate. This one clears no problem. My spare is up on a slant back carrier, but I think the stock spare should clear as well. Get you a "Trimax THC200 Universal Anti-Rattle Clamp Fits 2" Hitch" and this thing is solid as stone.
The hitch has held up over Alaskan roads towing a jeep, but it does not sit level in the receiver so the tiny little bit that it sags is exaggerated when the tow bar is connected. Paint starting to peel with wear after a year.
# 11
Draw-Tite Hitch Extender for 2" Hitch Receivers - 18" Long
I was surprised by just how solid and heavy it was made. Just what I needed to move my Bobcat UTV hitch back to I can use it as my yard dog to shift my trailers around and not worry about the plastic tailgate nor the plastic bed getting damaged. The hitch sits under the bed and this extends it out so it is useable.
The hitch extension worked perfect. The only one that was 18" pin to pin which was exacty what I needed to make this combo work. Dual hitch to start. Top whole a luggage rack to haul coolers and the bottom for the bike rack. Thanks etrailer.
# 12
Curt Hitch Extender for 2" Trailer Hitches - 14" Long
The items I ordered will allow me to adapt my utility trailer for transporting my sea kayaks. Curt and Hopkins are both quality manufacturers. On a shipping note, the box arrived at the Post Office broken wide open. Your shipping folks need to wrap small, heavy, items in bubble wrap. Then stabilize it with foam peanuts. Just putting it in a box then stuffing the box with craft paper does not cut it. Items were not damaged so I am good to go.
This extender does a pretty good job of keeping my bike away from the rear radar system in my Venza so the backup warning system does not engage in error. Beware it’s pretty heavy.
# 13
MaxxTow Trailer Hitch Receiver Adapter - 2" to 1-1/4" Hitch - 11" Long
Installed my 2” hitch but don’t have a 2” bike trailer yet. I purchased this to continue to use my 1.25” bike trailer (until I find a deal). Used this over Thanksgiving weekend on I35 in Texas (tons of traffic)and I’m very pleased with the performance. I’m was secure and bikes traveled just fine.
I ordered this adapter from e-Trailer so I could extend my bike rack past my spare tire on my 2005 Honda CRV. This solved my problem and this thing is well made to take the weight. I'm glad I purchased from e-trailer because I know now that they sell quality products as I have also purchased a new receiver, ball mount and 2' ball to pull my trailer. If your goal is quality, great service and fast shipping then e-Trailer is one company to go with.
# 14
Trailer Hitch Adapter - 1-1/4" to 2" Hitch - 4-1/2" Drop/5" Rise - 6-1/2" L
Perfect and simple item. It was easy to install. I purchased an accessory with receiver opening of 2” and my jeep had 1 1/4 receiver.
I love it! It’s allowed me to use a 2 inch bike rack on the back of my sedan in a safe manner.
# 15
Yakima EXO SwingBase Swing Away Hitch Extender - 2" Hitches
This is sobeasy to install! It only took me 20 minutes. This definitely gives me much needed storage space for my 2023 Thor Scope 18M
Stout and well executed. EASY to install. Could use some ergonomic tweaks (I’m 70), but overall is a very good value. We’ll see, cuz we haven’t gone 10K miles yet... etrailer rocks btw
# 16
Malone 2" Dual Purpose Hitch Receiver
Used the Malone 2" Dual Purpose Hitch Receiver to have a bike rack with two bikes on the upper Receiver and a 21' bassboat on the lower Receiver. Ran down to Florida Everglades, Florida Keys and back home. Almost exactly 4,000 miles. Hitch worked perfectly. I did find that you can not "jacknife" the boat as much or the bow of the boat will touch the bikes on the rack but that is to be expected. Hitch was quiet, strong and exceeded my expectations. Easy to install and looking forward to using it again in a month for another 4,000 mile road trip. Note: I drive fast and the roads are not always perfect. This is a sturdy Hitch Receiver. Hope this review helps you. Sorry, crummy photo as the Receiver is a "set it and forget it" product. Be well.
I bought this Dual Purpose Receiver at Twice the price of that Big online company because of reviews from owners that bought on both sites. After evaluating the reviews, I chose to go with etrailer because I have come to trust them as a company that gives you a great product that they will stand behind and they appreciate your business. I haven’t used this receiver yet, but can look at it and I am comfortable that I made the right choice. I will follow up with another review after I use it.
# 17
Trailer Hitch Receiver Adapter 1-1/4" to 2" Hitch - 6-1/2" Long
I put a 1.25" trailer hitch on a Ford Fusion Hybrid so I could mount one of my cargo baskets that require a 2" hitch on it. It worked fine to allow for this.
Working fine for me. It sticks out from behind car, but I like it this way as to reach it.
# 18
Titan Hitch Box Extension for 2-1/2" Trailer Hitches, 41" - 48" Long
Just received the 41/48 inch hitch extension today so haven’t actually used it. However, one can tell the high quality by looking at the welds and thick paint coating. This item is extremely heavy. I expected some weight to it, but it surprised me. Also, the tubing has very tight tolerances. I have two ball mounts, neither of which slid into the extension on their own. I had to pound them in and tap them out with a 3 pound hammer. Once paint and labels were scraped away by this action the ball mounts were able to be slid in by hand. This extension will be used on my dually carrying my truck camper. I’ll be towing an aluminum trailer with a Can Am Spyder. Total weight towed will be less than 2000 pounds so I don’t expect the extension to be subjected to any stress.
As per my last 3 orders here are some pictures of how I received the item along with what was broke or bent. I can fix it but I shouldn’t have to. So I will try elsewhere from now on cant deal with your shipping dept , anymore.
What our customers are saying:
"very easy to shop"