Recommended Replacement For An Atwood Propane Gas Detector 31013

Question

Question:

I need a tv propane gas detector. Model LP_DOB Part 31013 Serial PP00300190

asked by: Brenda M

0

Expert Reply:

Hi Brenda,

The Atwood 31013 unfortunately has been discontinued so you'd need to go with a completely new LP gas detector. We have a couple of surface mount style detectors that come with trim rings that will cover the old unit's cutout hole so you won't have any ugly gaps to try and fill. They can come with either just LP detection or with Carbon Monoxide detection as well; and can be purchased in either white or black.

Propane Gas Detection:
White # RS64FR
Black # RS44FR

Propane Gas And Carbon Monoxide Detection:
White # RS34FR
Black # RS54FR

expert reply by: Kevin C

0

Brenda M.

10/7/2024

I would like to purchase RS54FR please

Reply

Kevin C.

10/7/2024

@BrendaM You can add the # RS54FR to your cart by clicking on the hyperlink to go to the product's specific page and then hitting add to cart or by scrolling down to the # RS54FR on this page listed below in the "Products Referenced in This Question" section and clicking the add to cart button.

Reply

Answer 1

You can use the RV Propane Gas Detector #RS64FR to replace your current Atwood 31013 propane gas detector. This will also use a 12v, 2-wire installation like your current detector.

view full answer...

Answer 2

Since the Atwood 31013 LP Detector has been discontinued you can replace it with the RV Propane Gas Detector - 12 Volt - 2 Wire - Black #RS44FR. This detector is a surface mount design and can easily swap out your old unit in just a few minutes.

view full answer...

Answer 3

The RV Propane Gas Detector part #RS64FR is what I recommend using to replace the the Atwood RV Propane Gas Detector part 31013 (Discontinued). The mounting plate for this new detector will cover up any holes you had for the previous so it will be a…

view full answer...

Answer 4

Atwood is no longer in business so you'd have to switch over to a new brand in order to get what you need. We currently only carry the RV Propane Gas #RS44FR (white #RS64FR) which comes with two different trims (large: 7-1/4" long x…

view full answer...

Answer 5

The RV Propane Gas Detector part #RS64FR is what I recommend using to replace the the Atwood RV Propane Gas Detector part 31013 (Discontinued). The mounting plate for this new detector will cover up any holes you had for the previous so it will be a…

view full answer...

Answer 6

The 6-point system which has front, rear, and center jacks, is what some trailers come with from the factory. The aftermarket version is the 4-point which is front and rear jacks #LC358590. It provides front to back and side to side stabilization to…

view full answer...

Answer 7

The closest replacement an Atwood PPOO224730 33535E propane detector is the RV Propane Gas Detector - 12 Volt - 2 Wire - Black item #RS44FR. It only uses one power wire instead of two so it is slightly different. It measures 4-1/4" long x…

view full answer...

Answer 8

We do have a propane gas detector you can use to replace your Atwood model 31013. The Atwood 31013 is no longer available, so it will not be a direct replacement. We have the: -RV Propane Gas and Carbon Monoxide Detector #RS34FR for white, or the:…

view full answer...

Answer 9

Thanks for the picture! The Equal-i-zer 2-1/2" Weight Distribution Shank item #EQ90-02-4800 that you referenced has 3/4" holes that are spaced 1-1/4" apart. If the head of your EAZ-Lift system has the same spacing then this shank would…

view full answer...

Answer 10

You do not need to replace your Fastway e2 Weight Distribution #FA92-00-0800. As you suspected, a new shank is all it will take to get you going again. Fastway doesn't have one for a 2-1/2" receiver, but Equal-i-zer who makes Fastway does.…

view full answer...

Answer 11

Hi Brenda, The Atwood 31013 unfortunately has been discontinued so you'd need to go with a completely new LP gas detector. We have a couple of surface mount style detectors that come with trim rings that will cover the old unit's cutout hole…

view full answer...

Answer 12

We do have some LP gas detectors available, but none would be a direct replacement for your CCI 7770.2 / Pre Tell 22. From what I could find on your CCI 7770.2 / Pre Tell 22, it has dimensions of 6.25" wide x 3.9" tall. The RV Propane Gas…

view full answer...

Recommended Replacement For An Atwood Propane Gas Detector 31013

Continue Researching