Grease Seal that Fits Hub/Drum KA90831

Question

Question:

Need seal for trailer brake drum part# KA90831

asked by: Scott

0

Expert Reply:

The correct replacement seal you'd need for a hub/drum KA90831 which is a 3,500 lb axle is the part # 58846.

expert reply by: Jameson C

0

Answer 1

Yes. The KA90831 part number you referenced are a 10" x 2-1/4" drum so the #AKEBRK-35R and #AKEBRK-35L would work well for you. If you wanted to upgrade to a self adjusting brake assembly you could use part #AKEBRK-35-SA. These brakes do…

view full answer...

Answer 2

I recommend replacing your Furrion DV5100 with the Jensen RV Stereo, #JWM70A. This requires a cutout of 7-1/2" wide x 2-3/4" tall x 6-1/4" deep for overall installed dimensions of 10-3/8" wide x 3-3/4" tall x 7-1/4"…

view full answer...

Answer 3

If you've already tried resetting and cleaning the unit then you'll need to replace it. I recommend the Furrion RV Stereo - Single DIN - HDMI, AUX/USB, Bluetooth, NFC, App Control - 60W - 2 Zone - 12V Item #DV3300SBL to replace it. This…

view full answer...

Answer 4

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 5

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 6

The difference between an load range C and load range D tire in the same size is the capacity and psi rating. The two tires will still have the same dimensions and fit on the same wheel. The D rated tire has a higher capacity. For a ST175/80D13 like…

view full answer...

Answer 7

Even though I cannot comment specifically on the grease you used because I am not familiar with it, I can tell you the best grease for trailer bearings is a a grease with a rating of GC-LB, which just means it is made to withstand very high…

view full answer...

Answer 8

The 5.30-12 tires, being wider, are going to make more contact with the road. This means that the noise, and heat build up will be higher than a 4.80-12 tire but the rolling resistance will actually be less because the tire is larger diameter. The…

view full answer...

Answer 9

Since both a ST145/R12 size tire, like the Kenda Karrier S-Trail #AM10130, and a 5.30-12 size tire, like the Kenda K353 #AM10068, fit a 12 inch wheel, a ST145/R12 size tire can replace a 5.30-12 size tire. Keep in mind that these tires do have…

view full answer...

Answer 10

Great question, William! The Karrier ST225/75R15 #KE63KV is a KR35 while the Karrier ST225/75R15 #AM10303 is a KR03 according to Kenda. There is a slight variation in the tread pattern and from what Kenda says about them it looks like the KR03 is…

view full answer...

Answer 11

Trailer wheel bearings are specific to the spindle that is installed on the axle that is on your trailer. You will need to safely support the trailer, remove the wheel and tire, remove the grease cap, remove the cotter pin and washer that secures the…

view full answer...

Answer 12

The three most common lug stud sizes for a trailer are 1/2"-20, 9/16"-18, and 5/8"-18. In order to make sure you get the correct lug nuts you need to measure the lug studs on the trailer now as we have no way to look this up for…

view full answer...

Grease Seal that Fits Hub/Drum KA90831

Products Referenced in This Question

Product Page this Question was Asked From

Continue Researching