Recommended Jack To Replace Husky Brute HB4500 With Damaged Lower Jack Assembly

Question

Question:

Do you carry the lower jack assembly for the HB4500? The Part number is 87460.

asked by: Geoff P

0

Expert Reply:

I have a replacement jack option for you, but the lower jack assembly 87460 you mentioned for your Husky Brute Jack HB4500 has been discontinued as it was for the older model jacks. Since your lower jack assembly is damaged you will need to replace the entire jack instead.

For a jack with the same 4500lb rating I recommend the Stromberg Carlson Electric Trailer Jack - Drop Leg - A-Frame - 23" Lift - 4,500 lbs - Black # SC63VR which offers up to 23" of lift, has a 2-year warranty, and will be an direct replacement of your current jack.

I included a video of the # SC63VR for you to take a look at.

expert reply by: Samuel C

0

Answer 1

The circuit breaker of the Ultra-Fab Electric A-Frame Jack #UF38-944017 is designed to prevent the motor from drawing too much amperage and damaging itself. If you were to lower the jack all the way and then keep holding the button you eventually…

view full answer...

Answer 2

Since you are limiting your trailer to 10000lbs, and the average tongue weight is 10-15% of the trailer weight, you are looking at 1000-1500lbs tongue weight. With that said it is a good idea to use a jack with a larger capacity as it will be able to…

view full answer...

Answer 3

I took a look at the Stromberg Carlson Electric Trailer Jack #SC63VR and the Bulldog Powered Drive Trailer Jack #BD500199 I believe I have found a comparable solution. I know this is not exactly what you're looking for, however none of our…

view full answer...

Answer 4

While your frustration is understandable and we have a solution for you, I wouldn't be able to tell you with absolute certainty that using the Stromberg Carlson Electric Trailer Jack #JET-3755 will stop your tailgate from hitting the jack. The…

view full answer...

Answer 5

The Lippert Components #LC285318 uses a standard 3 inch on center bolt pattern. If the hole in your A-frame will accommodate those dimensions, and the tongue weight of your trailer is not greater than its 3,500 lb capacity, the #LC285318 will work…

view full answer...

Answer 6

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 7

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 8

It sounds like you are speaking of the wires for the brake magnets. If this is correct, you will need to connect one of the wires to the brake controller output wire on your trailer connector and the other wire will need to be grounded to a clean…

view full answer...

Answer 9

Yes, the Dexter Self-Contained Hydraulic Jack #DX72CR does come with a manual hand pump that can be used as a backup in the event of hydraulic malfunction.

view full answer...

Recommended Jack To Replace Husky Brute HB4500 With Damaged Lower Jack Assembly

Products Referenced in This Question

Product Page this Question was Asked From

Featured Help Information

Instructions

Miscellaneous Media

Continue Researching