Can a Slow Close Lid Be Added To a Thetford RV Toilets

Question

Question:

Slow close toilet lid for Thetford Style II Model #42070. Thanks

asked by: Randy D

0

Expert Reply:

I do have an option for you but we don't have any parts that allow you to upgrade to a slow-close lid feature on a toilet. We do however offer the Dometic Part-Timer RV Toilets which comes with the slow-close lid feature. They also have a ceramic bowl which is a nice upgrade. They are offered in standard height part # DOM57FR and low profile part # DOM67FR.

expert reply by: Conner L

0

Answer 1

I contacted Trimark in regards to a replacement part for the Trimark 030-0900. 030-0900 is actually a series number not a specific part number. To find the part number you will need to take the interior handle completely off the unit. On the back…

view full answer...

Answer 2

The OEM prep package consists of 4 "pucks" in the bed of the truck that will allow you to drop in puck style hitches for easy installation and removal, that gives you a completely clear bed when not in use. The B&W Companion OEM 5th…

view full answer...

Answer 3

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

view full answer...

Answer 4

Choosing the right height setting for your 5th wheel hitch is a combination of a few different variables. First of all you want your towing setup to be as level as possible. With your Montana High Country 340BH level you will want to measure from the…

view full answer...

Answer 5

Hey Jon; I was actually just talking to Furrion about heat options for the Chill Cube yesterday (1/21/2025). At this time, the only way to have heat with this unit is through a furnace on a ducted setup. The Furrion Chill Cube RV AC w/ Air…

view full answer...

Answer 6

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 7

No, it does not but Firestone does make one. It is the No-Drill Mount Kit for Firestone Air Tank and Compressor item #F2530. This will allow you to get the Firestone Air Command Extreme Duty Air Compressor with Tank item #F46VV installed and you…

view full answer...

Answer 8

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 9

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 10

Hi Jerry, For your 2025 Kia Sorento PHEV you would need the Curt Trailer Hitch Receiver #C37RV for the trailer hitch. The right light kit for your Sorento is going to depend on a few factors. For models with the tow package, like you stated you have,…

view full answer...

Answer 11

Thanks for all of the information Daniel! The Hellwig Big Wig Rear Anti-Sway Bar item #HE24MR will definitely fit your 2024 Ram 3500 diesel. This will work with both 2WD and 4WD models and is also compatible with the dually models as well. I have…

view full answer...

Answer 12

Hey Dan, thanks for reaching out! If you have the Progressive Dynamics 4000 Series System #PD4060K then it looks like removing the black and white wires will disconnect the converter section (see attached photo), which charges the battery. I do…

view full answer...

Can a Slow Close Lid Be Added To a Thetford RV Toilets

Products Referenced in This Question

Product Page this Question was Asked From

Continue Researching