Troubleshooting LED Auxiliary Lights Connecting to 4-Way Trailer Wiring

Updated 08/27/2020 | Published 08/25/2020

Products Featured in This Question

Curt Auxiliary LED Indicator Lights

(212)

$31.79

Dielectric Grease for Electrical Connectors, 2 oz.

(1459)

$10.96

Load Resistor Kit for LED Turn Signals - 50 Watts - 6 Ohm - Qty 2

(35)

$9.59

Question:

Hi, I have a 2014 Subaru Outback and installed the Curt Auxiliary LED Indicator Lights C53201 connected to the Hopkins Plug-In Wiring Harness HM11143865 for my bike rack. However when I tested the lights the following occurred - Curt lights are very faint and hardly visible from behind. - Running lights are active when car is on top row of LED - Applying the brakes turned the running lights off. And second row of lights do not turn on. - Turning indicators is operating differently on each side Left- both top rows of the curt are flashing Right- none flash and all Curt lights go out. Could you assist with any advice or troubleshooting. Thanks,

asked by: Ed

Expert Reply:

The Curt Auxiliary LED Indicator Lights # C53201 being an LED kit has very little power draw so even a slight connection issue can drastically impact function. I recommend cleaning each connection with sand paper and then using dielectric grease # 11755 to make sure the connections keep moisture and corrosion out.

if that doesn't solve the issue with function, then next step for LED lights is to add load resistors like # DI34ZR for the functions. This will create a draw like a light bulb to force the connections to have more power pull through them which often helps with LEDs that aren't functioning as desired.

expert reply by: Jason S