How To Reset Lippert Ground Control Auto Leveling System

Question:

Last time we camped the leveling system went out of stroke i did it manually but went to use again time an said to retract lr jack then something else had to do it again manually how do i reset so i can just hit auto level? Thank you

asked by: Mark

Expert Reply:

In order to "reset" your Lippert # LC358590 or # LC675817 Leveling system you'll want to follow these instructions:

1. In manual mode, run the jacks to level the trailer. This is best achieved by placing a level in the center of the trailer and leveling it both front to back and then side to side. (See “Basic Jack Operation” for instructions on how to manually operate the system).
2. Once the trailer is level, turn off the touch pad.
3. With the touch pad off, press and release the “FRONT” button five (5) times and then press and release the “REAR” button five (5) times.
4. The touch pad will flash and beep and the display will read “ZERO POINT CALIBRATION ENTER to set, Power to Exit”.
5. To set the current position as the zero point, press the “ENTER” button.
6. LCD display will read “Zero point stability check”.
7. LCD display will read “Zero point set successfully” once process is complete.
8. The system will set this point as its level state and the touch pad will turn off.

With that said, there may be an issue to where one of the jacks was over-extended and the gears have stripped, which is causing this error on the Left Rear jack. If this continues, please let me know and I can look into this further for you but you may need to replace that leg that is causing you issues.