Replacement Control Panel for Lippert Leveling System with Module 175226

Question

Question:

What touch panel will work with Lippert leveling control 175226/12656 ?

asked by: Kearney B

0

Expert Reply:

If you have the module part # LC175226 the correct replacement touch panel would be the # LC421484.

expert reply by: Jameson C

0

Answer 1

I recommend disconnecting 12V electrical power from the main system control panel for a few minutes. Usually about 15-minutes without power does it. This will reset the system and should operate as normal. Once reconnected to power if you still have…

view full answer...

Answer 2

More than likely the issue is going to be the control panel. There are a couple of things you can try before replacing your current panel though. The first thing you can do is to make sure that all of the connections on the back are solid and then…

view full answer...

Answer 3

It sounds you are looking for the Lippert 4 Point Control Panel W/ Amp Connector part #LC175225. The correct wiring harness to use with this control panel is the Replacement Lippert Components 4-Point Leveling System Control Brain Wiring Harness part…

view full answer...

Answer 4

The #LC53ED is the correct replacement control brain for the Lippert 4 point leveling system on your motorhome. It is essentially the same controller for ALL Lippert 4-point leveling systems. This leveling system is common on fifth wheels, but we…

view full answer...

Answer 5

Yes it will; Lippert has verified the correct replacement for your 175226/12656 control brain is indeed the following: - Replacement Lippert Leveling Control Brain for 4-Point Leveling System #LC53ED

view full answer...

Answer 6

Hey Beth, yes the Dometic FreshJet 3 part #DMC69ZR can replace your Dometic Duo Therm and would do a great job.

view full answer...

Answer 7

Hi Troy, I’m glad you reached out because there’s a bit of confusion around these model numbers and I want to make sure you get exactly what you’re expecting. The 35004-0792 and 45004-0792 Coleman Mach 10 you mentioned is a low profile 15,000 BTU…

view full answer...

Answer 8

Hello Eric, thanks for reaching out. If you are upgrading to the new R32 unit you will need to upgrade your entire AC system. The new AC unit would not intercommunicate with the controller and thermostat correctly, so you will need to use all Furrion…

view full answer...

Answer 9

Yes. The Lippert #LC175225 will be the correct part to replace the control panel on the Lippert 4 Point Leveling System currently on your 2012 Open Range 5th wheel, but you'll likely need to use the Replacement Lippert Components 4-Point Leveling…

view full answer...

Answer 10

The correct replacement circuit and control board for your Lippert Electronic leveling system is the Replacement Control Panel for Lippert Ground Control 3.0 and Travel Trailer RV Leveling System #LC421484. This will be a plug and play solution, so…

view full answer...

Answer 11

Yes the ports can be connected/bypassed on the Atwood RV Water Heater w/ Heat Exchange part #AT94023. This is basically a pre heating of the water using your coolant from the engine so it is ready to use when you reach your destination using the…

view full answer...

Answer 12

I recommend going with a tankelss water heater like the Furrion RV Tankless Water Heater - Gas - Automatic Pilot - 60,000 BTU - 16" x 16" Door, part #FR98SR. This water heater comes with a 16" X 16" door, which is approximately…

view full answer...

Replacement Control Panel for Lippert Leveling System with Module 175226

Products Featured in This Question

Continue Researching