Can Redline Locking L Style Door Handle # 276 Turn More than 90 Degrees

Question

Question:

Does this handle turn more than 90 degrees? The handle I need to replace for cargo door on the back of bus turns 180 degrees. Thank you.

asked by: Richard

0

Expert Reply:

There is nothing internally on the Redline Locking "L" Style Door Handle # 276 that keeps it from rotating freely. This will turn more than 90 degrees as long as your existing locking system allows this.

This handle features a 2-1/2 inch long shaft that is 5/16 inch square. Two keys are included.

expert reply by: Chris R

0

Answer 1

I checked with TRC and they sent me the following pictures for the Flat Rub Rail Trim for Enclosed Trailer #36286-955 that you referenced.

view full answer...

Answer 2

We can provide you with 3 of the Redline locking L style door handle #276, unfortunately we do not offer them with a keyed alike option. There are a wide variety of different key/lock combinations and we cannot guarantee any specific key number. We…

view full answer...

Answer 3

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 4

Hey Robert, thanks for reaching out. You asked a good question so I went ahead and ran that by my contact at Bauer. They said the Bauer NE RV Entry Door Lock #BA53UR can be programmed with up to 256 entry codes. I hope this helps and let me know if…

view full answer...

Answer 5

The closest door latch we will have is the Redline Full Size Locking Steel Flush Door Latch #L3980. However, this will fit a 3-3/8" x 4-5/8" cut out and will measure 4-1/4" x 5-1/2" so it will end up being too small for your door.…

view full answer...

Answer 6

Thank you for including your picture. The Redline Locking "L" Style Door Handle #276 definitely looks to be a replacement but I would also check the measurements between the mounting holes on your Casita to be sure. It is difficult to…

view full answer...

Answer 7

We have the Red Line handle, part #276, that has a 5/16 inch square shaft. It doesn't look as much like your handle as #PLR7011L, and isn't as heavy-duty, but it's the correct size shank and still locks. This is the closest option to your…

view full answer...

Answer 8

To replace your NOK AD2527E seal you can use #168233. It has an inner diameter of 1.688 inches and an outer diameter of 2.332 inches. Based on what I could find on the NOK AD2527E the inner diameter is the same and the outer diameter is 2.328 inches.…

view full answer...

Answer 9

You should still be able to use the liftgate feature on your 2022 Toyota Highlander with the Curt Trailer Hitch Receiver #C99FR (13453) installed. Instead of just swiping your foot under the bumper though you will need to kick to either side of the…

view full answer...

Answer 10

I went out to the warehouse to measure the distance between the mounting holes of the Redline Locking "L" Style Door Handle #276 and found it was approximately 1-1/2 inches.

view full answer...

Answer 11

The SAE number on the lens of a light isn't a part number so it's pretty hard to pick out the correct replacement light based just on it. The best option I would have for you would be to check out the link I attached that has all of the…

view full answer...

Answer 12

Thank you for the photo of one of the original decking fasteners from your aluminum snowmobile trailer. It appears your fastener has a taper at the point; but then again this might be erosion from exposure to winter road salts. We do offer several…

view full answer...

Can Redline Locking L Style Door Handle # 276 Turn More than 90 Degrees

Product Page this Question was Asked From

Continue Researching