Length of TorkLift FastGun Turnbuckle for 2015 GMC Sierra and 2011 Lance 825 Camper

Question

Question:

Hello, Im interested in the Torklift Fast gun turnbuckle tie downs. What size or length turnbuckle is needed for a 2015 GMC 2500 and a 2011 Lance 825 camper? I already have the Torklift frame mounted tie downs on the truck.

asked by: Scott

0

Expert Reply:

If you have the Torklift frame-mounted tie-downs then you will simply need the TorkLift Locking FastGun Turnbuckles for Frame-Mounted Tie-Downs # TLS9529-2-LK. These have a 25" - 43" reach and are designed for use with frame-mounted tie-downs for truck campers.

I have added a link to a video review of these tie downs for you to take a look at as well.

expert reply by: Kyle S

0

Answer 1

I can only help you pick out the best psi but I can't tell you off-hand exactly the best pressure to use. What you want to do is put in an equal amount of pressure in both bags till the truck is sitting as close to stock ride height as it did…

view full answer...

Answer 2

For the TorkLift Custom Frame-Mounted Camper Front Tie-Downs #TLC2220 the 1/2-inch bolt that is to be installed in the hole in the bottom of the front spring perch should be placed using the included coiled bolt fisher wire. Insert the coiled end…

view full answer...

Answer 3

Lance does have a proprietary plug, but many customers see a standard 6-way or 7-way round and notice it doesn't fit their factory 7-way as well. I've attached an article to help if you have one of the 7-way or 6-way round connectors which we…

view full answer...

Answer 4

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 5

We have run into this quite a few times in the past, and the best option will be replacing the Lance 7-pin connector with a standard 7-way blade connector like the #PK12706. This will give you a standard 7-way connector to plug into the factory 7-way…

view full answer...

Answer 6

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

view full answer...

Answer 7

Hello Mike, Sounds like you are getting things set up the right way and not going over your payload, I respect that. It looks like the weights are the same whether you have a 6 3/4' or 8' bed. If you happen to have an aftermarket hitch,…

view full answer...

Answer 8

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 9

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 10

Hello Bart, thanks for reaching out. I can definitely point you in the right direction, but I will need a bit more information on your truck before I can recommend the correct tie downs. Can you please answer the following questions for me? 1. What…

view full answer...

Answer 11

Hey Dan, yes the rear tie downs that come with the Torklift Tie Down set part #TL34VV do bolt to the trailer hitch at the rear of the truck. I attached a picture that shows our installer bolting it in that area.

view full answer...

Answer 12

Hi KJM; assuming you have the factory trailer hitch the correct TorkLift camper tie-downs for your 2024 Sierra 3500 dually is the Custom Fit Tie Down Kit With TL44FR | TL84FR #TL94PR. This will fit with that built-in step you're referring to as…

view full answer...

Length of TorkLift FastGun Turnbuckle for 2015 GMC Sierra and 2011 Lance 825 Camper

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching