How to Install 1/2-Inch Bolt in TorkLift Custom Frame-Mounted Camper Front Tie-Downs # TLC2220
Updated 09/08/2015 | Published 09/05/2015
Question:
2012 Gmc Denalli 2500, how do I get 2inch bolt in the oval hole for front tie down?
asked by: Dave
Expert Reply:
For the TorkLift Custom Frame-Mounted Camper Front Tie-Downs # TLC2220 the 1/2-inch bolt that is to be installed in the hole in the bottom of the front spring perch should be placed using the included coiled bolt fisher wire. Insert the coiled end into the hole on the bottom of the perch and run it out the side. Then attach the bolt's threaded end and pull it back through to its position as shown in the linked image from the instructions.
The complete install instructions are linked for you as well.
Product Page this Question was Asked From
TorkLift Camper Tie-Downs - Custom Frame Mount - Front
- Truck Camper Tie Downs
- Front Tie-Downs
- Frame-Mounted
- Custom Fit
- Powder Coated Steel
- TorkLift
more information >
Continue Researching
- Q&A: Installing a Brake Controller in a 2011 Chevy Suburban with Factory 7-Way Trailer Connector
- Q&A: Looking for Horse Trailer Door Latch Replacement
- Q&A: Replacement Monitor for a Voyager WVCMS130AP Camera
- Article: How to Mount a Truck Bed Camper
- Q&A: Does Firestone Air Bag And Compressor Kit Fit 2026 Ram Power Wagon 2500
- Q&A: Recommended Camper Tie Downs for a 2025 Ford F-250 w/a 6-3/4' Bed
- Q&A: Torklift Camper Tie Downs that Fit 2018 GMC Sierra 2500 Short Bed Double Cab
- Q&A: Recommended Front Camper Tie-Downs For A 2015 GMC Sierra 2500
- Article: Stability Control for Heavy Duty Vehicles
- Article: Choosing the Right Suspension Kit for Your Truck and Trailer