How to Clear Error Code on Lippert Ground Control Leveling System
Updated 08/04/2022 | Published 07/31/2017
Question:
I have an error code that says L F jack. it says to retract all jacks and hit enter to clear. i have tried that and a bunch of other things and still cannot get the error code to clear. sometimes the location of jack changes on display but always results in the same way. only had the camper for 2 weeks. it is a 2016 326rds cougar fifth wheel. any suggestions?
asked by: T.J. K
Expert Reply:
We have heard of this issue before on the Lippert Ground Control systems # LC358590.
Here is the recommended procedure for clearing the error code: Extend all jacks at least 6 inches. Then press and hold the RETRACT button until the jacks begin retracting. All of the jacks should fully retract and clear the error.
If that does not clear the error code disconnect all connectors to let the system power down completely for about 15 minutes. The re-connect and follow the procedure again if the error code reappears.
Product Page this Question was Asked From
Lippert Ground Control 3.0 Electric 5th Wheel RV Leveling System w Touchpad - 4-Point Set
- Camper Jacks
- 5th Wheel Camper
- Stabilizer Jacks
- Steel
- 10001 lbs or More
- Electric Jack
- 36 Inch Lift
- Bolt-On
- 4 Jacks
- Lippert
more information >
Featured Help Information
Instructions
Continue Researching
- Shop: Replacement Control Module for Lippert Ground Control 3.0 Electric Leveling System
- Search Results: 5th wheel hitch
- Search Results: 5th wheel gooseneck adapter
- Shop: Replacement Control Module for Lippert Ground Control 3.0 Leveling System - Prepped 5th Wheel RV
- Search Results: brake drums
- Search Results: gen~y hitch gooseneck coupler
- Shop: Dexter Trailer Idler Hub Assembly for 6,000-lb Axles - 6 on 6 - Agricultural
- Search Results: lippert controller
- Search Results: lippert
- Search Results: 807615
- Video: A Closer Look at the Blue Ox Leveling Kit with Wheel Chocks
- Shop: Replacement Front Jack for Lippert Ground Control 3.0 Leveling System
- Shop: Replacement Control Panel for Lippert Ground Control 3.0 and Travel Trailer RV Leveling System
- Shop: Dexter Nev-R-Adjust Electric Trailer Brakes - 10" - Left/Right Hand Assemblies - 4.4K
- Video: Lippert Ground Control 3.0 Electric Leveling System Replacement Control Module Review
- Shop: Advent Air Low Profile RV Air Conditioner System - Manual - 13,500 Btu - Black - R32
- Shop: Trailer Hitch
- Q&A: How to Reset Zero Point Calibration on Lippert Ground Control 3.0
- Video: Review of the Replacement Front Jack for Lippert Ground Control 3.0 Leveling System
- Video: Review of Lippert Replacement Hall Effect Sensor Wire Harness Ground Control 3.0 - LC65ED
- Shop: Base Plate for Tow Bar
- Q&A: Can a Hub with Outer Bearing 15123 and LM67048 Both Fit Same Spindle
- Video: Feature Breakdown: Electric Trailer Brake Assembly
- Video: Replacement Control Module for Lippert Ground Control 3.0 Leveling System: The Breakdown
- Video: Setting up the etrailer Electric Trailer Brakes on a 2017 Grand Design Reflection Fifth Wheel
- Q&A: Replacement Control Module For Control Module 346005 On 6-Point Lippert Ground Control
- Q&A: Troubleshooting a Lippert Level-Best Leveling System that Suddenly Stopped Working
- Q&A: How Do Self-Adjusting Brakes Adjust and Does it Work Going Forward or Reverse
- Q&A: Does Advent Air Low Profile RV Air Conditioner System Come With Everything Needed to Add New AC
- Shop: Trailer Wiring
on Camper Jacks
Joe
6/21/2020
I’m having the same issue with my Lippert gen 3 system. Battery died during leveling. Now the error won’t go away no matter what I do. Holding auto retract seems to cause an issue too. I swear my leveling system was made by the government. I have more problems with this leveling error than anything else.