Transmission Cooler Recommendation for 2011 Chevy Silverado
Updated 08/06/2020 | Published 05/06/2017 >
Products Featured in This Question
Question:
I have a 2011 silverado 1500 with a 5.3, 6 speed HD trans, 4x4 with 3.42 gears. I have a 28foot travel trailer and while towing trans temp goes up to 205-210 degrees. I wanted to know what temp is too hot and should pull over and would it be beneficial or recommended to add a trans cooler with a fan on it
asked by: Jonathan S
Helpful Expert Reply:
You are a little on the warm side for your transmission fluid. If you can keep it under 200 degrees you will have the max life out of it. That being said transmissions really start to go downhill at 260 degrees.
The Derale cooler part # D13503 with the install fitting part # D13018 is the most popular option for your 2011 Chevy Silverado 1500 and would work well. I attached an install video that shows the cooler installed in a similar GM vehicle.

Product Page this Question was Asked From
Derale Radiator Adapter Fittings for GM
- Accessories and Parts
- Transmission Coolers
- Radiator Adapters
- Derale
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Search Results: brake controller
- Search Results: trailer wiring
- Search Results: transmission coolers
- Search Results: trailer brake controller
- Shop: Derale Snap-In Radiator Adapter Fitting for GM
- Shop: Curt Trailer Hitch Receiver - Custom Fit - Class III - 2"
- Search Results: transmission cooler
- Shop: Hopkins Plug-In Simple Vehicle Wiring Harness with 4-Pole Flat Trailer Connector
- Q&A: Ball Mount with 4 inch Rise Recommendation for Use with Curt Hitch for 2003 Lincoln Town Car
- Search Results: locking hitch pin
- Search Results: hitch pin
- Shop: Universal Installation Kit for Trailer Brake Controller - 7-Way RV and 4-Way Flat - 10 Gauge Wires
- Video: Installing the Curt Trailer Hitch Receiver on your 2007 Ford Crown Victoria
- Shop: etrailer Trailer Hitch Receiver - Custom Fit - Matte Black Finish - Class III - 2"
- Shop: Draw-Tite Ball Mount for 2" Hitches - 2-3/4" Rise, 4" Drop - 9" Long - 7.5K
- Shop: 2" Hitch Ball - 1" Diameter x 2-1/8" Long Shank - Chrome - 7,500 lbs
- Video: Detailed Breakdown of the Pollak RV 7-Blade Plug End Socket w/Mounting Bracket
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Brake Controller Installation: Starting from Scratch
- Q&A: Is Reese Voyager and Tekonsha Voyager the Same Brake Controller
- Q&A: How are the Derale Adapter Fittings # D13018 Installed and Used to Install a Transmission Cooler
- Q&A: Recommended Brake Controller Adapter for Tekonsha Brake Controller on a 2016 Chevrolet Silverado
- Q&A: Brake Controller and Install Harness Recommendation for a 2002 Chevy Silverado 2500HD
- Q&A: Transmission Cooler and Suspension Enhancement for a 2011 Toyota Sienna
- Q&A: Replacement Hitch Hardware Recommendation for a 2003 Mercury Grand Marquis
- Article: Frequently Asked Questions About Transmission Coolers
- Video: Derale Snap-In Radiator Adapter Fitting for GM Review
- Video: Derale Radiator Adapter Fittings for GM Review
John C.
7/28/2020
I assume this would also be suitable for a 2011 Tahoe w 5.3L engine, 6-speed transmission, even though website says it's not a fit for that vehicle. Any other mounting hardware needed? There is currently no transmission cooler installed.
Jon G.
8/5/2020
John C.
8/6/2020