Can Reese Weight Distribution Shank 54998 be Used in Place of Reese Shank 54970

Question

Question:

I currently use the Reese 54970 with my Reese 66021 WD Hitch. I upgraded my trailer and now need to upgrade my hitch. I need a solid shank for my new Draw-Tite 7979-1 double tab hitch head which requires a solid shank. Both the shanks are same length and shape, except the 54998 is solid. Can I swap out the 54970 with the 54998 and install the hitch head in the same position on the 54998 that it was in on the 54970? I am posting a picture of my current setup with the 54970 and 66021 hitch head.

asked by: William M

1

Helpful Expert Reply:

Yes, you can use weight distribution shank # RP54998 in place of shank # RP54970. The hole spacing and size to mount the weight distribution head is the same on both shanks.

expert reply by: Michael H

1

click to enlarge

Answer 1

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 2

Hey Darrel, since you like the DeeMax 7k slip on kit the part number you'd need is the #DE46AR which comes with the slip on rotors and the needed actuator and lines. So for an idler hub what you'd want is the part #8-231-50UC1 and you'd…

view full answer...

Answer 3

Hey Don, Curt does have a Class V hitch for your Ram but it sits super low so it's not going to be what you want. Draw-Tite offers Trailer Hitch Receiver #DT45509. It has a 2-1/2" receiver tube opening, 18,000lb gross towing weight/2,000lb…

view full answer...

Answer 4

Hi Cliff; the inner diameter of the bearings used on 5,200-7,000 lb axles is the same so you can choose a higher rated hub to match the bolt pattern. You can use the Dexter Trailer Idler Hub Assembly - 5,200-lb, 6,000-lb and 7,000-lb Axles #42865-KIT…

view full answer...

Answer 5

I went ahead and attached a diagram that shows the spacing of the hangers on the 6-Leaf Slipper Spring w/ Hook End for 8,000-lb Trailer Axles - 29-1/2" Long #e46SR. This is the spacing you will use with the Tandem-Axle Trailer Hanger Kit for…

view full answer...

Answer 6

Finding replacement leaf springs for your 1967 Aristocrat camper will require some more information. You will need your axle capacity, current leaf spring length, and the shackle length. If you don't know your axle capacity, try checking the axle…

view full answer...

Answer 7

Hi Jeff! So the only combo with the 5 on 4-1/2 inch bolt pattern we have that provides that Load Range E rating is the Taskmaster Provider #TA56AR. It doesn't look like that tire is available by itself, either. This would certainly give you more…

view full answer...

Can Reese Weight Distribution Shank 54998 be Used in Place of Reese Shank 54970

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching