Best Honda Odyssey RV Vents And Fans

So far it's holding up with no leaks. Kind of on the flimsy side comparing to the one removed but easy to install. Couldn't use the trim ring inside but after a year still looks new and the lifting/lowering mechanism works smoothly. Overall a good price for the quality.

Purchased this because from Etrailer because they state made in USA. Nowhere is there a made in USA stamp or in print. It looks identical to the made in China ones for $[XX] cheaper on [online resale]. By the build quality I am quite sure that it is Disappointed to say the least

Product worked but wasn't worth the price paid. Ordered the white version which was cheaper and combined with other items for free shipping. Ordered 11/23; Kept changing the delivery till July 2024. You offered the black vents. Charged the higher price and also charged me freight. Turned me off as a customer by bait and switch. Forced me to find a better source for components.

Excellent product and easy to work with. Great service. I was concerned however about insects entering through the vents so came up with a filtration system. Used a PVC coupling and some filter material. Cut the coupling to 1/2 inch rings and remove just enough material to allow an inside press fit. Cut round filter and insert first then hold in place with the ring. On the outside vent cut a long narrow piece as shown. When installed as shown, adds very good double filter and allows air to move freely. Just finished a 6000 mile trip clear across the country and back and filter performed perfectly. Eliminating the heat build up AND keeping the bugs out. JIM : ]

Click to Enlarge

Click to Enlarge

Click to Enlarge

Click to Enlarge

The order was processed quickly and I was kept informed on the status with e-mails. Vent cover installation and fit up was easy. The mate up of the existing open/close mechanism was a little "fussy". But a re-review of the included instructions confirmed the correct orientation. After I applied a small amount of grease to the friction retaining clip and slide, it was working as good as new.

Pleasantly pleased with this vent cover. Its fit over the roof opening of our 20 year old hay trailer was a bit tight so the plastic dome wouldn't descend flush to the trailer roof. It seemed the closing edge opposite the hinge was bowed inward a little. (Might have been compressed during shipping, but the outside of the box was not damaged). Anyway, I was able to gently bend it outward without damage using a channel lock on the supporting galvanized brace which runs from the hinge to the opposite side. The excellent instructional video attached to the dome part on etrailer's digital shopping catalogue was very helpful. I changed the screen too. I was able to find an older style screen on the Walmart website which did not require me to drill a new hole for the crank handle as demonstrated in the instructional video on the etrailer.com site. At half the price as etrailer's screen and double the shipping cost from Walmart, cost for replacing my vent dome was a horse apiece. Thanks etrailer. I'm very happy.

Was missing the retaining clips on both items. The old ones were ok.

What I'd like to know is how ETrailer got my Roof Vent stuff to me so quickly. Not only that, but I get a note right after I ordered referencing a prior order (for the same thing...different trailer) and I'm saying to myself, "These folks take customer service to another level." Everything ordered was in the box and delivered intact.

Pretty easy install. It works great to let in fresh air without the rain and snow.

They are great I use on my snowmobile trailer.canleave the vent open all the time.

I just got the trailer roof vent, and it is a great product. I unboxed it and noticed it was made of quality material. The top half had nice wide corners with several predrilled holes for easy installation. The inside plastic parts were sturdy and well designed to fit just right. I will be replacing an old plastic roof vent on my 6x12 enclosed trailer. This roof vent will be a life saver because of its quality, and it will be able to handle the years of being in the elements to come. Plastic just doesn't last at all in elements. I would recommend this product to anyone who wants to save themselves a lot of time and money replacing the plastic model roof vents by purchasing one of these. Great Job folks!

No more breaking the roof vent on the trailer when shoveling off snow! Customer service was also excellent and shipped fast!

They look great. Well built, and etrailer is an excellent company. They shipped fast, packaging was good, and communication with the company by phone and email could not have been better.

Thank you for your prompt followup on my damaged merchandise. The replacement was great. Thanks for your good service, that says a lot about your company and will go a long way.

Overall seems like will work for me, but the box had been opened before (black fingerprints all over the unit). This is more a Ventline issue than etrailer issue as it came packaged in the original box. Also, they more clearly mark that there are no screws or other mounting equipment unless you buy the add on package.

Awesome very fast delivery, thank you will definitely shop again.

This fan has worked great for my motor home. If you need a stronger breeze, this may not be the fan for you.

Quick delivery and easy installation. My camper is a little older but this vent fan is an exact match. Bery happy with the removable screen for cleaning great feature the old vent didn’t have.

Hello all. I have a 1973 Apache Pop up, the original vent was missing so I looked online for a replacement and I came across this ventline vanaire roof vent, the vent fit perfectly in the original location of the old vent . This pop up has hard sides when you bring the roof down the side walls meet in the center but leave a gap between each other the handle for the vent fits perfectly in the gap. This memorial weekend we vacationed at Lake Isabella and it gets windy when the vent was closed it stayed closed no matter how strong the wind was. It was a success and worked perfectly. Thanks and I am a happy camper.

Click to Enlarge

Click to Enlarge

Click to Enlarge

Click to Enlarge

Click to Enlarge

Click to Enlarge

Click to Enlarge

Click to Enlarge

Click to Enlarge

I bought this 6" fan a year ago and it is still going strong. I mounted it vertically on the rear wall of my van conversion boxvan(RV Off-Grid Campervan) about 7" from the ceiling. It was a good fit because I didn't want to cut a hole in my roof and my ceiling. It pulls all of the hot air out of the room within less than a minute. If you want to mount yours vertically as well it will operate just fine with no flaws. Water has never leaked through the unit at all even while mounted on the wall instead of the roof. I recently recommended this fan to someone who needed a fresh air fan for summer as well in a van. Perfectly satisfied with this fan, recommend it and would buy again if the need arises! Thank You

Click to Enlarge

This was an exact replacement for my broken roof vent. I watched the videos available on the website and felt pretty good about swapping it myself. It arrives today. I took out the old one and put in the new one in about 30 minutes total. The roof vent install kit made it easy to ensure it was water tight.

Click to Enlarge

Click to Enlarge

Didn't take long to install. Very well made.

I love Etrailer, they have everyday parts as well as hard to find ones. I've ordered parts a couple of times , delivery is always spot on and George is very helpful. The butterfly vent I ordered fit exactly. Same holes no drilling.

Click to Enlarge

These butterfly vents were replacements on a 1994 horse trailer that we are refurbishing. The old ones were solid rust and couldn't be saved. Though today's vents aren't made as large as the old ones, we can make them work and are good quality for this job without a huge investment. We're waiting to install until after we repaint the outside of the trailer so no photos at this time. Fast shipping was also a plus. Thanks etrailer!!

Fair nice product

The attachment for the hinge that pushes the skylight open and closed is a cheap bit of plastic, so this winter the skylight took some wind and eventually sent that piece and the skylight flying. Fortunately, the base is screwed in so that was still available for reattaching and the skylight itself was not broken. Anyway, it’s jury rigged and still functional. Better than the original I guess.

Exactly what we needed as it keeps the windup vent from breaking off if it is left open while driving, as mine was

Click to Enlarge

Click to Enlarge

Easy to install. Product is made durable material that will last. Also works well in that I can leave my roof vent open without getting debris or rain inside with this cover design.

Put this in to get heat out of semi. Open side vent and turn fan on high exhaust wow what a game changer.

Click to Enlarge

Click to Enlarge

Click to Enlarge

Initially I was real apprehensive about getting this fan installed on my 16’ Casita. Not because I didn’t want the fan, believe me I did. The specifications alone were impressive, but the ability to run it like a ceiling fan, with the vent closed was hands down the most impressive feature. Something my little Dachshund Cinnamon would surely attest to. The front mounted ac unit in the 16’ Casita benifits greatly from this fan, it circulates the air better, cools things quicker and, helps maintain the temperature better. There is little information about putting this on a Casita, much less a 16’ one, but I’m happy with my decision to do so. This fan is awesome, and Etrailer was very helpful with information on my purchase. Another note was that I’m happy Terry my installer did this project, the factory installed Fan was riveted in from the top, and removing it wouldn’t have been a typical by the book procedure. Thanks George J. I’m one happy camper, and that’s without mentioning the remote control, air flow on low settings, great price, fast delivery, or quietness of the product. Sincerely, A. McCord Sgt. US Army Ret.

Click to Enlarge

Click to Enlarge

I waited several months before writing a review so that I could make sure this replacement cover didn't leak. It hasn't! It was really easy to install which I did myself. For reference, I'm a 53 year old woman. Our trailer is an enclosed aluminum trailer, and this cover fit perfectly.

Click to Enlarge

Click to Enlarge

The cover came very quickly and securely in the mail, very durable, well constructed and stream-lined. Installed fairly easily with your on line installation Tudors. Unfortunately my base has a different type hinge, so a few minor challenges, but for the most part doable. I still need to find a friction clip to secure my top to the actuator mechanism, but hopefully I can find it locally. Our Arizona sun destroys most plastics as our original cover had failed in about five years. I am very pleased with my new cover top, looking to it meeting and exceeding our needs!

Click to Enlarge

Click to Enlarge

Click to Enlarge

Click to Enlarge

Easily and effortlessly installed. They are made of nylon or flexible plastic I believe. White, powder coated aluminum would have been better but after a few hours of searching these were the nicest looking and the best price.

Click to Enlarge

Click to Enlarge

Hi Carol, I bought a lot of things from etrailer, I'm looking for two rear doors for my trailer, do you sell doors for a 24x60 triailer, or where can I find them? thanks

Click to Enlarge

Delivery was timely, the color is perfect, and they fit without having to change the bracket.

Click to Enlarge

RECEIVED THE VENTS AS ORDERED, AND VERY TIMELY. THEY FIT PERFECTLY. ONE OF THE VENTS HAD A BROKEN HINGE, SO I CALLED CUSTOMER SERVICE. I WAS GREETED BY A FRIENDLY REPRESENTATIVE WHO SAID SHE WOULD SEND OUT ANOTHER VENT RIGHT AWAY. I WOULD USE ETRAILER FOR ANY ITEMS I MAY NEED FOR MY MOTORHOME.

I'm really disappointed with the flimsy material and poor finish quality. At first I thought mine might have been defective, but if you zoom in on the product photos that are provided, you'll see that there's lots of flash and rough edges. Mine is a bit worse than the one in the list, but still I'm not going to permanently affix this to my $100,000 motorhome

Click to Enlarge

My new trailer came with a stove vent that exhausted to the inside of the trailer making it unbearable to cook inside in the hot sun of Florida. I modified the fume hood so it could vent through the wall the way it should have been in the 1st place. This plastic vent cover worked as good as any could be expected to do so and provided a neat appearance to finish off the modification. Reasonably priced to boot.

Click to Enlarge

James was great to work with over the phone. He knew his stuff and very nice to work with. He assisted me in making sure that the roof vent cover was the correct fit (and it was). It was an easy install and will keep the rain out during our wet Northwest winter.

Perfect fit for 2015 Airstream Ventline bath fan. My fan only said “Modre VP”. This part was perfect and installed in 5 minutes.