Most Popular Roof Vent for Honda Odyssey

So far it's holding up with no leaks. Kind of on the flimsy side comparing to the one removed but easy to install. Couldn't use the trim ring inside but after a year still looks new and the lifting/lowering mechanism works smoothly. Overall a good price for the quality.

Installed this vent into my Haulmark Transport 6'x12' enclosed trailer. Installation was easy, I cut a 14.25" x 14.25" inch hole between two crossmembers in the roof and dropped it in place. Because the roof on this enclosed trailer is so thin, I used a piece of 3/8" plywood so sandwich between the interior garnish and actual vent. I cut the same size hole into the plywood and left a 2" lip all around. I use 28 #8 x 5/8" stainless screws to hold it in place, pre-drilled with 1/8" bit. I then used roofing tar to seal the vent and put masking tape all around, leave 1" from the flange to ensure good coverage. I then removed the masking tape, leaving nice clean lines. Interior garnish is held in place by #8 x 3/8" galvanized screws. Huge kudos to etrailer for carrying such awesome products for great low prices and offering super cheap shipping to Canada!

Click to Enlarge

The order was processed quickly and I was kept informed on the status with e-mails. Vent cover installation and fit up was easy. The mate up of the existing open/close mechanism was a little "fussy". But a re-review of the included instructions confirmed the correct orientation. After I applied a small amount of grease to the friction retaining clip and slide, it was working as good as new.

Pleasantly pleased with this vent cover. Its fit over the roof opening of our 20 year old hay trailer was a bit tight so the plastic dome wouldn't descend flush to the trailer roof. It seemed the closing edge opposite the hinge was bowed inward a little. (Might have been compressed during shipping, but the outside of the box was not damaged). Anyway, I was able to gently bend it outward without damage using a channel lock on the supporting galvanized brace which runs from the hinge to the opposite side. The excellent instructional video attached to the dome part on etrailer's digital shopping catalogue was very helpful. I changed the screen too. I was able to find an older style screen on the Walmart website which did not require me to drill a new hole for the crank handle as demonstrated in the instructional video on the etrailer.com site. At half the price as etrailer's screen and double the shipping cost from Walmart, cost for replacing my vent dome was a horse apiece. Thanks etrailer. I'm very happy.

Shipping was above average, very quick. Product was what I expected, HOWEVER The last one I purchased from another co. Included all the required screws. I was miffed when I opened the box and saw no screws, and the directions which I do not need were for a different application. Overall pleased.

Was missing the retaining clips on both items. The old ones were ok.

Pretty easy install. It works great to let in fresh air without the rain and snow.

They are great I use on my snowmobile trailer.canleave the vent open all the time.

I just got the trailer roof vent, and it is a great product. I unboxed it and noticed it was made of quality material. The top half had nice wide corners with several predrilled holes for easy installation. The inside plastic parts were sturdy and well designed to fit just right. I will be replacing an old plastic roof vent on my 6x12 enclosed trailer. This roof vent will be a life saver because of its quality, and it will be able to handle the years of being in the elements to come. Plastic just doesn't last at all in elements. I would recommend this product to anyone who wants to save themselves a lot of time and money replacing the plastic model roof vents by purchasing one of these. Great Job folks!

No more breaking the roof vent on the trailer when shoveling off snow! Customer service was also excellent and shipped fast!

Overall seems like will work for me, but the box had been opened before (black fingerprints all over the unit). This is more a Ventline issue than etrailer issue as it came packaged in the original box. Also, they more clearly mark that there are no screws or other mounting equipment unless you buy the add on package.

Awesome very fast delivery, thank you will definitely shop again.

This fan has worked great for my motor home. If you need a stronger breeze, this may not be the fan for you.

Quick delivery and easy installation. My camper is a little older but this vent fan is an exact match. Bery happy with the removable screen for cleaning great feature the old vent didn’t have.

Hello all. I have a 1973 Apache Pop up, the original vent was missing so I looked online for a replacement and I came across this ventline vanaire roof vent, the vent fit perfectly in the original location of the old vent . This pop up has hard sides when you bring the roof down the side walls meet in the center but leave a gap between each other the handle for the vent fits perfectly in the gap. This memorial weekend we vacationed at Lake Isabella and it gets windy when the vent was closed it stayed closed no matter how strong the wind was. It was a success and worked perfectly. Thanks and I am a happy camper.

Click to Enlarge

Click to Enlarge

Click to Enlarge

Click to Enlarge

Click to Enlarge

Click to Enlarge

Click to Enlarge

Click to Enlarge

Click to Enlarge

I bought this 6" fan a year ago and it is still going strong. I mounted it vertically on the rear wall of my van conversion boxvan(RV Off-Grid Campervan) about 7" from the ceiling. It was a good fit because I didn't want to cut a hole in my roof and my ceiling. It pulls all of the hot air out of the room within less than a minute. If you want to mount yours vertically as well it will operate just fine with no flaws. Water has never leaked through the unit at all even while mounted on the wall instead of the roof. I recently recommended this fan to someone who needed a fresh air fan for summer as well in a van. Perfectly satisfied with this fan, recommend it and would buy again if the need arises! Thank You

Click to Enlarge

This was an exact replacement for my broken roof vent. I watched the videos available on the website and felt pretty good about swapping it myself. It arrives today. I took out the old one and put in the new one in about 30 minutes total. The roof vent install kit made it easy to ensure it was water tight.

Click to Enlarge

Click to Enlarge

Didn't take long to install. Very well made.

Fair nice product

The attachment for the hinge that pushes the skylight open and closed is a cheap bit of plastic, so this winter the skylight took some wind and eventually sent that piece and the skylight flying. Fortunately, the base is screwed in so that was still available for reattaching and the skylight itself was not broken. Anyway, it’s jury rigged and still functional. Better than the original I guess.

Exactly what we needed as it keeps the windup vent from breaking off if it is left open while driving, as mine was

Click to Enlarge

Click to Enlarge

Easy to install. Product is made durable material that will last. Also works well in that I can leave my roof vent open without getting debris or rain inside with this cover design.

James was great to work with over the phone. He knew his stuff and very nice to work with. He assisted me in making sure that the roof vent cover was the correct fit (and it was). It was an easy install and will keep the rain out during our wet Northwest winter.

Perfect fit for 2015 Airstream Ventline bath fan. My fan only said “Modre VP”. This part was perfect and installed in 5 minutes.

This roof vent is a real game changer for us. It allows us to open and vent our teardrop, even in the rain. Design is sleek. Lock works well. Fan is excellent and quiet.

Click to Enlarge

I purchased this maxxfan to replace the roof vent unit that came on our camper. This new vent fan is whisper quiet and best of all it can remain open while its raining. The install was easy and it fit the original hole perfectly. Used the TremPro 644 sealant also sold by etrailer and the install came out perfect. Thank You! etrailer for quick shipments and quality products.

Click to Enlarge

I installed this myself on a vintage camper. It fit perfect in the space where the old vent was. Wiring was simple, and cutting down the bezel was easy. I have left this open for months and even in storms and no rain gets in. Being able to keep it open keeps the camper from getting musty. I also like the tinted skylight effect it gives.

Click to Enlarge

Work great, no problems with rain, snow or leaks. With solar panels we leave both fans on while Class A is unoccupied to keep humidity down and temperature cooler inside rig. We are very satisfied

Click to Enlarge

The 2250 Fantastic Fan still working great after a year! Pretty quiet and the thermostat is a handy feature that works well. In my application, it has a tendency to open itself while driving around unless it has been cranked down fairly hard. Driving with it open doesn't seem to be a problem other than the outside noise that comes in that way. My application was a fiberglass raised top on a Chevy van. I had to make a wood frame as the fiberglass did not provide a flat surface to mount to. Photos below show inside frame, fan, and insulation.

Click to Enlarge

Click to Enlarge

Click to Enlarge

Click to Enlarge

This is the second Fantastic fan I have purchased to replace the two vent fans on an older Airstream trailer. Fit, form and function are perfect for my needs. Installation was easy and the fan works perfect.

I installed this as a bathroom fan through the sidewall of my T@B teardrop camper. Works great.

Click to Enlarge

Product is fine will update once installed. etrailer yall got yo do something about your terrible shipping. I mean order on 7th of March delivered by Pony Express on the 15th. Yall got to do better. Not ordering again unless they ship thru someone other than USPS! Slowest Shipping on internet!

Great direct replacement. Went on easy used all the hardware supplied. No problems. Replaced all three covers on my 2017 Newmar Dutch star.

Perfect replacement lid for fan-tastic vent 2000DMS older model on 2005 class-c mtrh...exactly the same. 4 screw installation and the hole patern same. Easy install 30 minutes.

Click to Enlarge

Click to Enlarge

Installation was not difficult and fan works well in tight areas.

All products I've purchased from etrailer have been just as one should expect from a reputable product dealer. For me its the informative videos and sales staff. thanks again

I really like how low profile this fan is both above the roof and inside. Since I installed this in an e350 van with low roof, I needed the thinnest possible option. I am considering buying a rain cover, because if it rains I have to be sure to close this vent

Click to Enlarge

Replaced my camper trailer AC unit (which I never use) with this roof vent. Was super easy replace and came with screws and connectors. The fan isn't whisper quiet (not sure if I got a buggy one), but fine for what I needed.

These little solar vet caps Work just fine! None-the-less, For all my PVC/ plastic roof top covers they fall victim to squirrels! The refrigerator Vent cap alone has been replaced 3 times in about 9 years.

I have installed these vents on two 7'x14' trailers that are used to store kayaking gear (boats, paddles, helmets,PFD's,clothing and other soft goods). Hoping that the constant air-flow will help prevent mold & mildew. I can already feel the difference in temperature (cooler) than prior to installation. They work, but the construction is so lightweight, I'm wary of how long they'll last. For $[XX], it seems they could construct them a little beefier.

Click to Enlarge

Click to Enlarge