If your 2020 Explorer is equipped with the factory 7-way trailer connector, it will have the brake controller connector under the dash. The connector is located under the dash, above and to the right of where the driver's right knee would be. The…
Hi Ray! We can definitely get your 2020 Ford Explorer EcoBoost set up with wiring to tow your new pop-up camper. Since you don't have any wiring yet, you will need to start with the Curt T-Connector Vehicle Wiring Harness with 4-Pole Flat Trailer…
Hey Scott! The Waltech Vision 2.0 #WA74FR can replace those thermostats if they are Dometic 3-wire single zone, 12-button zone CCC, or 5-button multi-zone. See the attached photo. I'm assuming these are R410A AC units (pre-2025). If they're…
In order to replace your Carrier Air V RV Air Conditioner I highly recommend using the Advent Air Replacement RV Air Conditioner for Carrier Setup part #ACCAR135 for 13,500 Btu's or part #ACCAR150 for 15,000 Btu's. This unit will be the only…
When installing a trailer wiring harness on your 2020 Ford Explorer The T-One Vehicle Wiring Harness with 7-Way Trailer Connector #118272 is not confirmed for your vehicle. Since your vehicle had the harness stripped out I recommend The T-One Vehicle…
Hey Derrick! The Dometic RV Furnace #DMC94RR will pretty much work with any RV thermostat that is capable of running a furnace. The only one that might give you trouble is the Furrion Chill Cube wall thermostat since it seems to have issues with a…
I checked with Curt and the Curt Trailer Hitch Receiver part #CU78FR is listed as a fit a 2020 Ford Explorer with kick sensors. That said, the fit with the kick sensors is tight so there are a few things you need to do during installation to ensure…
Hi John; the step on the Benton LittleShift Bike Rack #B54VR does not have a specific weight rating. It is capable of holding the max tongue weight capacity of your hitch so most adults will be able to use it for sitting/standing. We also have the…
Thanks for the question Roy, and you're not looking at much fascia trimming at all on your 2024 Ford Explorer to install the Curt Trailer Hitch Receiver #CU78FR. If you check out the attached photo from the instructions you can see it's just…
The Curt #C56306 fits the 2011-2019 Ford Explorer. Since you have the 2020 or 2021 model this will not fit. There are no plug and play options for a 7-way but you can still add one. The first thing you will need is the T-One Vehicle Wiring Harness…
If you watch the attached install video for the brake controller install harness part #3035-P at the 9:45 mark you can see how we took the interior apart on a similar Ford Explorer to route the wiring as well as access the connector you need to use.
In regards to selecting a tongue jack for a trailer, it only needs to be rated for the tongue weight of the trailer which is usually 10-15% of the gross trailer weight (GVWR). For example, if the trailer has a gross trailer weight of 5,500 lbs then…
