Custom Fit 2018 Jeep JK Wrangler Unlimited Accessories

Hey Jacob! If your 2018 Jeep Wrangler Unlimited came with that 4-way connector from the factory, all you'll need is the Hopkins Endurance Quick-Install 7-Way Trailer Connector item #HM42190. This one plugs directly into your Jeep's factory…

The RoadMaster BrakeMaster Custom Seat Adapter #RM-88287 that you referenced is designed to allow the installation of a Roadmaster Brakemaster like part #RM-9160 in your 2014 Jeep Grand Cherokee.

Replacement safety cables are available for the etrailer XHD Non-Binding Tow Bar #e94ZR with the Demco Straight Safety Cables #DM9523055 which are 64 inch long straight safety cables.

Hello Mark, Per the tech at Lippert you are going to want to use AW-32 Hydraulic Fluid, and not an automatic transmission fluid.

What you need for your 2014 Wrangler Rubicon with the 10th Anniversary bumper is the Blue Ox Base Plate Kit #BX1134. The #BX1126 will not fit. See the picture below where the #BX1134 is installed on another Wrangler with the same bumper.

It sounds like there might be some other fuses that could have blown, or there are some shorts on your brake controller/7-way circuits. It is hard to know exactly where the problem lies, but the first thing I would check would be to test the manual…

Sometimes brake controllers need to be reset as they get a weird internal bug. Try unplugging yours for a minute or so and replugging in and see if that helps. Here's how to test the controller though: Testing the brake controller is fairly easy.…

You won't have any problem with power going to the brake controller all the time. This lets the brake controller keep all of its settings and not lose them every time the vehicle is turned off. Brake controllers are designed to enter a sleep mode…

According to Dexter Axle, it's perfectly normal for the display to light up and display .0 when a trailer isn't connected. This will happen regardless of if the vehicle is running, as the controller has a constant 12V connection to the…

The manual override lever does not move when you hit your brake pedal but the digital display will light up and give you a reading. The slide is only for the manual emergency braking or to apply additional braking pressure to your trailer as desired…

If the manufacturer recommends to ground the Tekonsha PowerTrac Electronic Brake Controller part #39523 to the negative side of the battery terminal then this is what you should obey. However, we have installed hundreds of brake controllers by…

Brake controllers such as the P3 you referenced #90195 will go into a sleep mode after about 15 minutes of it sensing no movement. If you peek through the window after 15 minutes then it should be in sleep mode. Opening the door or causing movement…