Custom Fit 2013 Jeep Wrangler Unlimited Accessories

No, the Hopkins Custom Tail Light Wiring Kit for Towed Vehicles #HM56200 is sending power to the lights and not pulling power from them to send out to the 4-pole connector. There are plug-in style trailer wire harnesses available though that I can…

I had our warehouse measure the Lock N Roll Articulating Hitch for 2" Receivers - 4-1/2" Drop/Rise #336VS517 you were looking at, and from the center of the hitch pin hole to the center of the hole that the pin on the trailer side…

The Replacement Pin Sleeve part #RM-A005116 has an inner diameter of 7/8 inches and an outer diameter of 1 inch.

Yes, you can flat tow your 2017 Jeep Wrangler JK, that has a AEV front bumper, using a Blue Ox #BX1133 Base Plate Kit, as long as your Jeep has the bolt on tabs as shown on page 4 of the Blue Ox installation instructions attached. Most Jeep owners…

Whether or not you can flat tow with a Jeep bumper is really up to the manufacturers testing; some of the big names like MetalCloak or Poison Spyder have bumpers with D-ring attachments that can be used for flat towing connections. This is great…

The vehicle side of the Lock N Roll Articulating Trailer Hitch #336VS501 can be locked to the vehicle's 2-inch receiver hitch using any standard pin lock such as #e98880. The mating part that bolts or welds on to the trailer #336TS508 will only…

For a hitch pin for the Lock N Roll Articulating Hitch w/ 3-Position Channel #336VS503505 I recommend the InfiniteRule Locking Pins for Lock N Roll Articulating Hitch for 2" Hitches - Qty 2 #IR59FR. This set of pins is specifically designed for…

I spoke with my contact at Lock N Roll about the Lock N Roll Articulating Hitch part #336VS503505 and they were not quite sure what measurements you are looking for nor was I. That said, I went out to our warehouse for you and jotted down a few…

Even with the rear axle of your motorhome being a decent distance from the rear of it there will still be rocks and other debris that will fly up from the wheels and potentially hit your vehicle. The Rock Guard part #RM-4000 will definitely help.…

The Replacement M10 Channel Nut for Rhino-Rack Accessories #RR89TB has a M10 thread size and base dimensions of 35mm x 19mm x 8mm.

The holes on the Lock N Roll #336VS503505 are spaced 2" apart center on center, so you'll have 4.25" at the lowest/highest and then roughly 2" rise/drop and 0" rise/drop in the various positions it offers.

If your 2013 Jeep Wrangler Unlimited has the standard factory bumper you can use EZ4 base plates #RM-521448-4. If it is a 10th anniversary addition but does NOT have the American Expedition Vehicles bumper you can use #1444-1. If it is a MOAB…