2011 Lincoln MKX Trailer Hitch
2011 Lincoln MKX Trailer Wiring
2011 Lincoln MKX Brake Controller
2011 Lincoln MKX Towing Mirrors
2011 Lincoln MKX Base Plate for Tow Bar
2011 Lincoln MKX Vehicle Tow Bar Brake System
2011 Lincoln MKX Vehicle Tow Bar Wiring
2011 Lincoln MKX BOLT brand vehicle and hitch locks
2011 Lincoln MKX Roof Rack
2011 Lincoln MKX Trunk Bike Rack
2011 Lincoln MKX Air Filter
2011 Lincoln MKX Suspension Enhancement
2011 Lincoln MKX Performance Chip Tuners
2011 Lincoln MKX Vehicle Lights
2011 Lincoln MKX Tire Chains
2011 Lincoln MKX Fluid Filters
2011 Lincoln MKX Salt Spreader
2011 Lincoln MKX Vehicle Engine Heaters
2011 Lincoln MKX Radiator Fan
2011 Lincoln MKX Cabin Air Filter
2011 Lincoln MKX Floor Mats
2011 Lincoln MKX Nerf Bars - Running Boards
2011 Lincoln MKX Vehicle Covers
2011 Lincoln MKX Side Window Vents
2011 Lincoln MKX Mud Flaps
2011 Lincoln MKX Vehicle Seat Covers
2011 Lincoln MKX Windshield Wiper Blades
2011 Lincoln MKX Windshield Covers
2011 Lincoln MKX Vehicle Air Mattress
Videos
for Lincoln MKX Owners
Help Articles
Expert Answers
I reached out to my contact at Lippert and they said that it sounds like you just aren't holding the 4 buttons for the reset long enough. It requires 5 seconds, but many people will count to 5 a little too fast and the system won't…
Actually the hitch part number you mentioned of 87604 is no longer available but for a similar hitch made by the same company we have the Draw Tite #75992 which would fit and work well. It does have drilling listed as a requirement as all of the…
The Draw-Tite Max-Frame Trailer Hitch Receiver #75992 does state to use a 7/16 inch drill bit in the instructions. This is engineers helping with installation instructions for precision but you are correct most people will use a 1/2 inch bit or use…
The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…
The Pro Series cargo carrier part #63153 does have a hollow shank so you can use an anti-rattle device with it easily. We do not sell just the internal block of the anti-rattle device part #63232 that you referenced so your best option would be to…
The J-style kayak carriers will certainly add a little more wind drag as opposed to the kayaks resting flat against the roof rack. For a flat-style carrier you could look into the Malone SeaWing Kayak Carrier #MPG107MD or the Rhino-Rack Nautic…
On the Hopkins tow bar wiring harness #HM56002 on your 2011 Lincoln MKX you will have to cut off the 4-Way flat end and hardwire each of the wires to the back of the 6-Way contained in kit #RM-98146-7. I have included a link to a help article that…
The Hopkins Custom Tail Light Wiring Kit #HM56002 is confirmed to fit the 2011 Lincoln MKX. This wiring harness will provide you with a 4-way flat connector at the front of your vehicle to connect to your RV while flat towing. I have attached help…
The blank screen on your LCI Ground Control 3.0 could be either a power issue or a control module issue. I recommend first remove the panel and unplug it from the back leaving it unplugged for at least 15 minutes so that it loses all of the residual…
More than likely the issue is going to be the control panel. There are a couple of things you can try before replacing your current panel though. The first thing you can do is to make sure that all of the connections on the back are solid and then…