2010 Honda CR-V Trailer Hitch
2010 Honda CR-V Trailer Wiring
2010 Honda CR-V Brake Controller
2010 Honda CR-V Towing Mirrors
2010 Honda CR-V Base Plate for Tow Bar
2010 Honda CR-V Vehicle Tow Bar Brake System
2010 Honda CR-V Vehicle Tow Bar Wiring
2010 Honda CR-V Roof Rack
2010 Honda CR-V Trunk Bike Rack
2010 Honda CR-V Air Filter
2010 Honda CR-V Suspension Enhancement
2010 Honda CR-V Transmission Cooler
2010 Honda CR-V Performance Chip Tuners
2010 Honda CR-V Vehicle Lights
2010 Honda CR-V Tire Chains
2010 Honda CR-V Fluid Filters
2010 Honda CR-V Salt Spreader
2010 Honda CR-V Vehicle Engine Heaters
2010 Honda CR-V Radiator Fan
2010 Honda CR-V Cabin Air Filter
2010 Honda CR-V Floor Mats
2010 Honda CR-V Trim Kits
2010 Honda CR-V Vehicle Covers
2010 Honda CR-V Grille Guard
2010 Honda CR-V Bug Shield
2010 Honda CR-V Side Window Vents
2010 Honda CR-V Mud Flaps
2010 Honda CR-V Vehicle Seat Covers
2010 Honda CR-V Replacement Mirrors
2010 Honda CR-V Windshield Wiper Blades
2010 Honda CR-V Windshield Covers
2010 Honda CR-V Vehicle Air Mattress
Videos
for Honda CR-V Owners
Help Articles
Expert Answers
Thank you for the picture. What you have there is the Roadmaster Falcon 2 #RM-525. This model is made specifically to go with Blue Ox brand base plates. For your 2010 Honda CR-V I recommend the Blue Ox Base Plate #BX2246. That will be everything…
The cost of setting up a 2008 Honda CR-V to flat tow is going to vary quite a bit depending on what you use and how much of the installation process for each item you do yourself versus paying someone to complete. Flat towing is a very expensive…
There are a couple of differences between the two. The JetStream bars like #Y00425 are made of extruded aluminum while the CoreBars such as the #Y00421 you've looked at are constructed of galvanized steel. As you've mentioned, the CoreBar has…
Inno and Thule crossbars are very similar in size but they are not interchangeable per Thule as they haven't been tested together. So they will fit but you would void any warranty if interchanging manufacturer parts. Thule no longer makes their…
There are a couple of things that set the Rhino Rack system using #RRVA150B-2, #RRRCH4, #RRRCP43-BK apart from the Inno system that uses parts #INXB138-2, #INXS350, #INTR154 you're looking at. I'll start out by saying that when it comes to…
Your 2008 Honda CR-V is a popular vehicle for towing behind a motorhome and we can help you get yours all set with the items needed for safe and legal flat towing. The linked overview article has lots of helpful information and is a great place to…
Thanks for the photo, and there is nothing that comes with the rack specifically would go over the factory moldings of your 2021 Mazda CX-9 when installing the Rhino-Rack RVP Roof Rack for Fixed Mounting Points #RRRVP51. That said, per the…
Yes, the Roadmaster Sterling All Terrain Non-Binding Tow Bar #RM-576 includes the crossbar that is shown in the linked photo. It also includes safety cables.
The wires for your Hopkins Custom Tail Light Wiring Kit for Towed Vehicles, #HM56300 is be run under the vehicle. Feed it through frame components as shown in the attached installation video for a 2008 Honda CR-V.
It depends on which tow bar you use. I would go with 24 inches on center between the tabs on Blue Ox base plates #BX88230. That will make them compatible with most, if not all, Blue Ox tow bars. I have included a link to the Blue Ox tow bars for…
According to the installation instructions, the brackets for #BX88230 require a spacing of 21-1/8 inches. You will first locate the center of your bumper and measure out 10-1/16 inches to either side, then from the center of each mark, measure over…
According to my contact at Blue Ox, their Bolt-On Base Plate Bracket Kit #BX88230 needs to be installed as close as possible to a 24-inch spread for use with their Alpha Tow Bar. You have at most 1 - 2-inches of leeway either wider or narrower. Since…