Hello Steven, thanks for reaching out. This sounds like one of two things. Either a bad ground, or a bad converter module. A bad ground can cause all kind of weird lighting issues, and it is by far the most common cause of problems with these wiring…
You are correct that both the Curt #C94WR and Draw-Tite #DT22MR you were looking at for your 2022 Hyundai Tuscon are very similar. Both hitches share the same 525lb tongue weight and 3,500lb trailer weight ratings, both share the same hidden…
I do have a solution for you, however when I spoke with my contact at Lippert they said that your axle is rated for 5,200 lbs and the highest rated standard axles that we have are rated for 3,500 lbs. The alternative solution that we have is the…
For your Homestead trailer with a 3,500lb axle I recommend the Dexter Trailer Axle Beam with E-Z Lube Spindles #7359765. This is a straight axle that shares your same hub face measurement. The spring center on this axle is only 80" so you might…
Hey Dave, what you gave me is enough info to get you replacement bearings. The grease seal 471750 matches the part #TMK48ZR. For a Timken replacement for the L44610 part number you'd need #TMK63VR. Then for a bearing for the L44649 you'd want…
In the installation video for Draw-Tite hitch #36455, which I have linked for you at right, you can see the position of the installed hitch at the 1:20 mark. This shows an underside view of the 2011 model year's rear bumper after hitch…
Basically a lot depends on what you will be using the hitch for. If it is just for accessories such as a bike rack or cargo carrier than for the most part you will be fine with a Class II trailer hitch. If you will be towing then I would go with the…
For a complete towing setup for your 2010 Chrysler Town and Country I recommend going with the Draw-Tite Max-Frame Trailer Hitch Receiver #75579 which is a Class III hitch with a 2 inch receiver opening. To install wiring I highly recommend the…
I called AL-KO and they informed me that there were two different hub assemblies for a 1994 Rockwood 2040 Pop-Up Camper. In order to choose the right hub you will have to do one of two things. You can either measure where the inner and outer bearing…
Thank you for your recent wiring harness purchase from etrailer. This harness is a plug-and-play type that uses connectors, rather than all separate wires that need to be spliced, for most of its connections to your Town and Country's wiring. The…
You can use the 4-way bracket part #18144 to hold the 4-way connector of the Curt harness part #C56333. This would attach to the bottom of the rear bumper and would do a great job to hold the 4-way when not in use so that it's not dangling behind…
