Hey Dominick, thanks for reaching out! The Draw-Tite Max-Frame Trailer Hitch Receiver #75105 weighs 48-1/2 lbs. Just out of curiosity, what was your reasoning behind needing to know the weight?
Hello John, The Fastway e2 Weight Distribution w/ Sway Control - Round - 6,000 lbs GTW, 600 lbs TW #FA94-00-0600 is an excellent weight distribution hitch! I prefer systems that use bars and brackets over those with chains, they just work better in…
Hey Phillip, we have a replacement 7-way for your 2005 Toyota Tundra with the Hopkins part #HM43385. This has a 4-way off to the side of it as well but can be used with 7-way adapters as well.
Hello Henry, When choosing the correct weight distribution system, you want to be as close to your loaded tongue weight as possible. Typically, tongue weight falls between 10–15% of your overall trailer weight. If you were at the heaviest tongue…
I reached out to my contact at Draw-Tite and they believe the Draw-Tite Trailer Hitch Receiver - Multi Fit - Class IV - 2" #37130 will fit your 2000 Toyota Tundra with the factory towable bumper, but they can't confirm it absolutely will…
Thank you for the picture of the rear bumper of your 2006 Toyota Tundra. Based on seeing that the Draw Tite hitch part #75105 that you referenced will fit it. I attached an install video for this hitch on a similar Tundra as yours for you to check…
The Draw-Tite Max-Frame Trailer Hitch Receiver part #75105 is a confirmed fit for your 2006 Toyota Tundra as long as you are willing to remove the factory hitch if equipped. I went out to our warehouse and measured the overall dimensions for you…
Hey Pete. The Norcold RV Mini Fridge w/ Freezer - 3.3 cu ft - 12V - Black item #NC37VR pulls 5.2 amps or 62.4 watts. What kind of trailer or RV do you have?
The Draw-Tite Max-Frame Trailer Hitch Receiver - Custom Fit - Class III - 2" #75105 is a confirmed fit for 2000-2006 Toyota Tundra models with or without factory towable bumper. It is very possible that the manufacturer used different nut and…
Hey Jon; I was actually just talking to Furrion about heat options for the Chill Cube yesterday (1/21/2025). At this time, the only way to have heat with this unit is through a furnace on a ducted setup. The Furrion Chill Cube RV AC w/ Air…
I reached out to Bear and they were able to confirm that your 3,500lb axles use a #84 spindle. This will allow you to use the Hub Bearing Kit #BK2-100 on each of your axle hubs. The kit includes new inner and outer bearings and races, a grease seal,…
I would start by inspecting the connector on your trailer and the vehicle to make sure there is not corrosion in the connector which could be causing a bad or weak connection. If there is corrosion in the trailer side connector, you would need to…
