1972 Jeep CJ-6 Replacement Top

Good question, Chuck! You will not need the Brake Relay #RM-88400 when installing the Roadmaster 4 Diode Wiring Harness #RM-15267 on your 2018 Jeep Wrangler JL Unlimited. This is because the stop light switch circuit on your Jeep JL will go dead…

Hey Neal, we have confirmed with Curt in the past that the front hitch part #C73ZV is confirmed to fit your 2022 Ram 2500 Power Wagon. What are you planning on putting in the front hitch?

Hello Christopher, We do not have the bow system for your 1993 Isuzu Amigo, and that is part of the roof frame. That is required, as well as the factory hardware for a replacement soft top, so if you have that you can use the Pavement Ends Replay…

Both the Roadmaster and Blue Ox tow bars are great options. But if it was my decision to make I would go with the Blue Ox Avail part #BX7420 as we have found that the Blue Ox tow bars are a little easier to connect and disconnect from. Also this tow…

Although the #TASR35HDS04 Timbren Axle-Less suspension you'd looked at has a 3500 lb capacity but is compatible with hubs that would have a 5200-7000 lb capacity, depending on which bearing set is used. We don't offer an idler hub compatible…

I have another option for you, but the Timbren Heavy-Duty Axle-Less Trailer Suspension - Straight Spindle - Regular Tires - 3,500 lbs #TASR35HDS04 you were looking at actually uses 5200lb hub and drum assemblies and is not available with the 5 on…

What you need is the Roadmaster Brake Lite Relay Kit part #RM-88400. This will prevent your brake pedal brake light activation from overriding the turn signals like you are experiencing.

Whenever you are testing for the cold side of the brake switch you'll want to use a volt meter like #PT89ZR rather than a standard test light, which I assume you are since you gave me the numbers of the read outs. The cold side of the brake…

The Roadmaster Diode 7-Wire to 6-Wire Flexo-Coil Wiring Kit, part #RM-15267, is the best option for you to use to flat tow your 2017 Jeep Wrangler. It will provide a 6-Way wiring harness to the front of your Wrangler that you can connect to the 7-Way…

While we do not have the Blue Ox EZ Light Wiring Harness that you mentioned installing on your Jeep, I was able to locate the installation instructions for the kit. It looks like the converter box that you mentioned is designed to protect the wiring…

Yes the Roadmaster diode tow bar wiring kit part #RM-154 is a fit for your 2018 Jeep Wrangler JK Freedom Edition. Roadmaster does not recommend the use of the brake light relay part #RM-88400 with this either on your vehicle.

It sounds like you've created your own umbilical to go from the 7-way on your RV to a 7-way on your Jeep. The Hopkins connector #H20043 is 4 feet long, which isn't going to be long enough to bridge the gap of space for flat towing. You're…