Expert Review Video:
Tow Bar Wiring Specs:
Accessory Parts:
Features:
...transmitter and receiver kit, and mounting kit Made in the USA Specs: Universal fit for all vehicles Requires 12-volt power port Cord length: 11-1/2' Light bar length: 17" Note: If y...
Installation Notes:
Fuse(s) must be pulled during towing. If you have a 4 cylinder model, leave fuse #32 intact and pull the ABS fuse instead. Note: some models may label ABS fuse as #15 or #16. You will also need to install part RM-156-25; sold separately
You will need to install a Charge Line Kit; sold separately
Tech Tip:
4-cylinder models will require fuse bypass RM-76517, while V6 models will need to use part number RM76511.
More Information >Videos
for Tow Bar Wiring
Help Articles
for Tow Bar Wiring
Expert Answers
for Tow Bar Wiring
If you are installing just the Firestone Ride-Rite kit, #F2400, and not also adding an on-board air compressor such as #F2158, then I would estimate that it should take about 2 hours to install the kit. That is for someone with some mechanical…
view full answer...I&…
view full answer...If your current springs have 5 leaves then going to a 7 leaf spring will increase the height of the trailer a little and make the trailer more susceptible to sway. Regarding capacity if you go with springs rated higher than what is required it will…
view full answer...Your trailer looks awesome! The Road armor equalizers #LC696740 and Equa-Flex Cushioned Equalizers #LC279687 are both pretty similar in performance even though the Road Armor has two dampers. The main difference is the size of the equalizers. The…
view full answer...If your old axles have a 5 bolt brake flange the assemblies like Dexter Electric Trailer Brake Assembly -…
view full answer...The Trailer Leaf Spring, 2250 lbs. 6 Leaf, item #e27SR, is sold as a replacement spring for older trailers and measures 26 inches for eye to eye, center to center. If you are replacing the springs and hangers you will need to use the same center to…
view full answer...Assuming your Sprinter has the factory tow package with the 7-way at the rear bumper, in addition to the #RED24FR Redarc Tow-Pro Liberty Brake Controller,…
view full answer...The best option we offer for your dump trailer is the Erickson Mesh Tarp and Truck Bed Cover part #EM57059 which measures…
view full answer...I would be happy to! To flat tow your 2024 GMC Canyon Denali you will need the following parts: Tow Bar and Safety Chains - Roadmaster Nighthawk All-Terrain Tow Bar w/ LED Lights item #RM-676 Base Plate Kit - Roadmaster Direct-Connect Base Plate…
view full answer...What you need for your Isuzu NPR truck is a powered converter #C59236. It is compatible with incandescent and LED trailer lights. I have included a link to the installation instructions for you. This harness does require a direct connection to the…
view full answer...The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…
view full answer...I would be happy to confirm the parts you referenced fit your 2019 Chevy Colorado and are compatible together. I have listed them below, along with any changes, and attached installation videos. Roadmaster Nighthawk All Terrain, Non-Binding Tow Bar…
view full answer...