Anti-Sway Bars Specs:
Features:
Minimize sway and driver fatigue by improving the stability and driveability of your vehicle. The bar on this sturdy, effective anti-sway system mounts to the rear axle and to the frame to balance weight transfer and reduce body roll.
Installation Notes:
No drilling required for installation
Retains factory swaybar
Product fits vehicles with a V10 engine.
Tech Tip:
Product fits coaches which are less than 34 feet long.
More Information >Anti-Sway Bars Specs:
Features:
Minimize sway and driver fatigue by improving the stability and driveability of your vehicle. The bar on this sturdy, effective anti-sway system mounts to the rear axle and to the frame to balance weight transfer and reduce body roll.
Installation Notes:
No drilling required for installation
Retains factory swaybar
Product fits vehicles with a V10 engine.
Tech Tip:
Product fits coaches which are less than 34 feet long.
More Information >Features:
...is durable and resistant to damage caused by oil, gasoline and ozone Less wear means less give in your anti-sway system and better support 2 Bushings and necessary hardware included Made in USA Superior...
Installation Notes:
No drilling required for installation
Product fits vehicles with a V8 or a V10 engine
Tech Tip:
Product is replacement kit for vehicles with 1-1/2 OEM bar. Some endlink parts may not be used when installing product.
More Information >Features:
...is durable and resistant to damage caused by oil, gasoline and ozone Less wear means less give in your anti-sway system and better support 2 Bushings and necessary hardware included Made in USA Superior...
Installation Notes:
No drilling required for installation
Product fits vehicles with a V8 or a V10 engine
Tech Tip:
Product is replacement kit for vehicles with 1-1/2 OEM bar. Some endlink parts may not be used when installing product.
More Information >Videos
for Anti-Sway Bars
Help Articles
for Anti-Sway Bars
Expert Answers
for Anti-Sway Bars
On a 2005 Chevy Silverado 1500, If you are facing the front of the truck looking at the power distribution box, there will be a post at the back left side and a fuse slot near it. It is that fuse slot that you will install a 30 amp fuse. I have…
view full answer...The 40 amp fuse for your 2006 Chevrolet Silverado tow package is used for the 12 volt battery charge circuit. This fuse is located toward the front of the underhood fuse box closest to the front auxiliary positive post (see photo). There may be a…
view full answer...The only way you could power interior dome lights on a trailer without it being connected to a tow vehicle would be to power the lights with a battery like a breakaway battery. How you choose to wire up the batteries will in the end be up to you,…
view full answer...For your enclosed trailer application I have several suggestions for adding interior lighting that you can control directly via a switch. Since your current 4-pole trailer wiring does NOT include a 12V auxiliary power feed that could power inside…
view full answer...The Roadmaster Exact Center Steering Stabilizer w/ Custom Brackets #RM47MR typically comes centered and you would only need to make adjustments after installation and testing to see if it continues to pull. If you adjusted it all the way out to…
view full answer...When installing/adjusting the Solera RV Slide-Out Awning #LCV000163285 tension is applied by rotating the awning roller 14 times. This should apply the needed spring tension so that the fabric doesn't billow in the wind or…
view full answer...I would love to help you upgrade the suspension on your Twilight 2800 travel trailer. The MORryde Rubber Equalizers for Tandem Axle Trailers #MR87ZR that you referenced are a great solution but we do need to double check a few things. First is that…
view full answer...The torque spec for the rear U bolts on your 2019 F53 motorhome are dependent on the size. If you have 3/4 x 16 u bolts (and used a 1 1/8" socket to remove the nuts) then they torque to 250 lb-ft. If the u bolts are 7/8 x…
view full answer...The Hellwig Adjustable Big Wig Rear Anti-Sway Bar #HE94FR is only going to leave a few inches between it and the spare tire, as you can see in the attached picture. Depending on how far forward you have the tire it could potentially interfere with…
view full answer...Thank you for purchasing from etrailer! You did a great job selecting compatible parts. When using Leaf Springs #e64SR with the #AP233 Equalizer Kit and the #H248 Hanger Kit, there should be 29-1/2" between the front and…
view full answer...On oil bath hubs the seals are different than standard grease seals. The correct replacement for what you have is #91030. Unitized oil seals like this have a part that stays fixed and a part that rotates with the hub for optimum leak protection. I…
view full answer...According to my research, your 92865A-1 hub/drum has a 25580 inner and an 14125A outer bearing and a 8 on 6-1/2 inch lug pattern, as does the AxleTek #AKHD-865-7-2-K hub drum you referenced. The #AKHD-865-7-2-K would be an acceptable replacement…
view full answer...Filter Products (8)