2004 Suzuki Grand Vitara Spare Tire Bike Racks

To move the arms you just need to push up on the spring loaded bolts to release the arms and swing them into place. That will move the arm up and allow you to move it freely back and forth. When you release the end of the arm with the nut and…

For your 2015 Jeep Wrangler Unlimited Sahara we have the Rampage Mass Articulation Front Recovery Bumper #RA88509 that fits which has 1-inch D-rings so you could use the D-Ring adapter part #BX88358 with your Blue Ox tow bar.

You can install a Yakima SpareRide 2 Bike Rack - Spare Tire Mount - Folding Arms #Y02599 on a 2020 Jeep Wrangler JLU, but it's likely going to…

The 205/65-10 and the 20.5 x 8-10 would be very close in size. Assuming that 20.5 is the diameter of the tire and 8 is the width. The Kenda 205/65-10 Bias Trailer Tire with 10 inch White Wheel, #AM3H390, for example, is 8.3 inches wide with a…

The best hitch for your 2023 Jeep Wrangler is the Curt Trailer Hitch item #C13392. This hitch is custom fit and bolts to your Jeep with included hardware. This is a class III hitch with a…

The backing plate of the Surco Bike Rack part #BT300 that you referenced attaches to the rim by it sliding over the mounting plate for the wheel and then using the lug nuts that attach the wheel to the vehicle as a way to secure the wheel and the…

What you need is a light kit specifically for flat-towing. The Plug-N-Tow TM Vehicle Wiring Harness, #42615, would be if the Jeep were towing a trailer and not for activating its lights while it is being towed. There are a few options for lighting…

The Malone Hanger Spare Tire Carrier #MPG2147 will work on the spare tire of your daughter's 2021 Jeep Wrangler since the width of your factory spare…

The way your 1988 Suzuki Samurai is currently setup, you have both combined and separate lighting systems. The combined system means the stop and turn signals are on the same circuit whereas the separate lighting system means the stop and turn…

I do have a solution for your 2001 Honda CR-V, however using a 1-1/4" x…

When installing any trailer hitch you would have to use all attachment points specified in the instructions. So if you wanted a higher capacity hitch like #13314 you would have to have that center tow loop welded back onto the vehicle. You will…

You would have to measure from your hitch pin hole out to the furthest point out on the rear spare of your 2007 Toyota RAV4 to determine if the #C18030 will clear it. The rack has a distance of 7-3/4 inches from the pin hole to nearest portion of…