Videos
for Search Results
Help Articles
for Search Results
Expert Answers
for Search Results
It is certainly possible for any axle to wear out enough over time to need replacing. Since the suspension is built into a torsion axle if the suspension part was to wear out pretty much the only solution would be to replace the axle. If the…
view full answer...The distance between the mounting holes on the back of the Buyers Products 5-Position Channel with Gussets #337B8979 that you referenced is 10 inches.
view full answer...To check the pins on the vehicle side 7-Way, you can use a circuit tester or the volt meter. The circuit tester will show you if a signal is coming through on the pin you are testing while the volt meter will tell you that and how much voltage is…
view full answer...If you don't mind drilling Jeremy I would recommend using all three mounting holes of the Dexter Actuator part #DX89FR or if you know a welder just have them weld it to the trailer. If you were going to only use two though use whichever two line…
view full answer...Your picture is of a coupler that is also a brake actuator for hydaulic brakes. Very much like part #DM72VR although not exactly. Connecting the trailer to your tow vehicle is just the same as any other it's just harder to see. Under the coupler…
view full answer...The use of Lock N Roll Articulating Trailer Hitch for 2" Receivers #336VS501 does not add sway to the setup. Couplers normally can articulate to the left and right like what this allows so it would not be any more prone to sway than a ball style…
view full answer...Since the Lippert 3,000 lb axles use the same components as the 3,500 lb axle the hub drums you'd need are the #AKHD-545-35-K and the brake assembly set #AKEBRK-35-SA and you'd be set. The hubs come with all of the bearings and seals…
view full answer...You will need to measure the diameter of the spindles where the seal and bearings ride. Check out the picture I attached that shows where this is. You will need an exact measurement so either a digital or dial caliper will be needed. To pick out the…
view full answer...The Dexter brake actuator part #DX89FR that you referenced can be used with tandem axle disc brake trailers.
view full answer...Based on the 6,000 lb GVWR of your tandem axle 2011 Lance 2185 travel trailer, the option that is most likely to work is the Torflex Lift Kit - Tandem Axle #K71-707-02. However, you do need to verify that your Lance travel trailer has a Dexter #10…
view full answer...Are there any visible signs of wear on the magnets like exposed windings then that would indicate they need replacing. Magnets can go bad without showing visible signs of wear though. To see how to troubleshoot them check out the help article I…
view full answer...The 4400 lb axle has spindles that are compatible with the #L68149 inner and #LM67048 outer bearing, the #LM67010 inner and #L44610 outer race and a 10-19 grease seal like part #RG06-050. We don't offer this as a kit, but the parts are available…
view full answer...Filters
3944 results
Related Searches