Videos
for Search Results
Help Articles
for Search Results
Expert Answers
for Search Results
Hey Tom, all I really need to know to pick out the correct bearings would be the axle capacity of your 2023 Grand Design 390RK. Since we happen to already know you have 8k axles the correct bearing kit would be the #DX38ER which comes with new…
view full answer...The Dexter "8-256" is a hub assembly that uses an L68149 inner bearing and a L44649 outer bearing. This hub assembly was offered in a few different bolt patterns therefore you would need to confirm your bolt pattern using the attached help…
view full answer...It sounds like your assemblies are not the typical assemblies and will need to be replaced. For your brake assemblies, I recommend the Electric Trailer Brake Kit - Self-Adjusting #AKEBRK-7-SA along with mounting hardware #BRKH12. If you don't…
view full answer...Yes, you can switch from using a Tang Washer #5-101 to the Spindle Nut Kit #RG05-100. This kit includes 2 Retainers #6-190, 2 Nuts #6-191 and 2 D-Washers #5-23.
view full answer...The MTI number on your 8-201 hubs is simply a casting number. It does not indicate any information about the hubs or have anything to do with the actual part number. I'm not surprised to hear you have different outer bearings between the two…
view full answer...You actually shouldn't be using a B&W Companion hitch with a Sidewinder at all. The problem is because of the single attachment point and the force applied to the hitch from the Sidewinder it could cause the gooseneck hitch under the bed to…
view full answer...I can certainly help you with that. Since the Curt T-Connector Vehicle Wiring Harness, part #C55384 is a 4-way connector the four functions will be Yellow for the left turn and brake, Green is for right turn and brake, Brown is for running lights,…
view full answer...Yes, you can replace the hydraulic brake assemblies of your trailer with electric ones. It would just be a matter of removing the hubs, removing the old assemblies, installing the correct size/rated ones, and then wiring the assemblies back up to the…
view full answer...Hey Travis, Overslung suspensions have the leaf springs above the axle and underslung systems have the leaf springs below the axle. We offer conversions kits to switch between these styles, but you'll need to first measure the diameter of your…
view full answer...The spoke with Dexter and the code "D100G" tells me you have two 10,000 lb trailer axles. I have attached some parts you may need for the axle below. Dexter Trailer Hub Drum Assembly (After July 2009) - part #8-430-5UC3 Dexter Trailer Hub…
view full answer...The correct bearing kit for your Dexter 10" Hub-and-Rotor Assembly #K08-435-05 is the following: - Hub Bearing Kit for Lippert, Dexter, and Al-Ko Axles #BK2-100
view full answer...Hey Dave, yes the Timken grease seal part #TMK58ZR is a replacement for what you have now. I would go with the Timken but we also do carry your exact part number replacement with the part #58846.
view full answer...Filters
- 1806 results