Hi Bill; since you're running to a single appliance you can use the JR Products RV LP Gas Manifold - 3 Port #JR45CR. You will also need #JR52CR or #JR32CR to make the connections along with the JR Products RV LP Gas Manifold Hose Disconnect Tool…
We have previously confirmed with Dometic (who own Atwood now) that the Atwood 91349 that you've got can be replaced by the Replacement Control Panel for Atwood Water Heaters #AT91367 you were looking at.
A direct replacement for your Winntec Model 6020 is the Automatic Changeover RV LP Gas Regulator #37207-30395 as the BTU rating is compatible and they have the same fitting sizes.
Hey Mark, To plug the unused ports on your JR Products RV LP Gas Manifold #JR65CR you'll just need the JR Products RV LP Gas Manifold Plug #JR25CR. We also offer a couple of adapters to make your connection to the ports easier: 1/2" x…
I would be happy to help! The Roadmaster Comfort Ride Leaf Spring Suspension Kit w/ Shock Absorbers - Tandem 7K Trailer Axles #RM-2460-2570 is for trailers that have 7000lb tandem axles, and use springs that have a 3500lb capacity each (one spring on…
The kit we offer that is designed for connecting an RV propane tank with an auxiliary tank is the MB Sturgis Quick Disconnect Deluxe Sturgi-Stay Propane Adapter Kit #103539-MBS which is designed for exactly what you are describing.
I have a solution for you but there is not a direct replacement for your old Atwood unit. Instead, you can use the 2-Wire RV Propane Gas and Carbon Monoxide Detector - 12 Volt - White #RS34FR to replace your old Atwood carbon monoxide detector, but…
You will be able to upgrade your #PD4045KA to use lithium batteries, and in order to do this you'll need to replace the converter (there isn't just an added part aside from the converter that will allow you to do this). So what you need for…
The design of the Progressive Dynamics 4000 Series Mini RV Converter #PD4045KA hasn't changed much, but the key is to look for the converter section. The switch is located on the converter's circuit board and will have in white "LA"…
The MB Sturgis Propane Adapter Hose - 3/8" Male NPT x 1/2" Female Flare Swivel uses a 3/8" fitting on the regulator side and 1/2" fitting on the manifold side. These are nominal fitting sizes so they don't actually measure…
Most regulators like the part #CAM59005 have an inlet of 1/4 inch SAE and an outlet of 3/8 NPT. It would be out of the ordinary if your tank to regulator wasn't 1/4 inch SAE inverted flare. Part #CAM59053 has this style of fittings on both sides.…
Hi Alex; are you specifically looking for the TorkLift extension? The #TLE1636 is designed for the factory 3" receiver on Ford trucks. Do you have the TorkLift SuperHitch #TLD1109 on your Ram? If you do, the TorkLift SuperTruss Hitch Extension…
Filters
