Videos
for Search Results
Help Articles
for Search Results
Expert Answers
for Search Results
I went out to our warehouse for you and measured the Tandem Axle Jeep Style Trailer Fenders part #HP62VR. The top part has a radius at each end so there isn't exactly a set point to measure from but I did my best to get the center of the radius…
view full answer...I confirmed with my contact at Dexter Axle that the grease zerk used in their EZ Lube spindles like #TRU74FR is a standard 1/4-inch pipe thread fitting that you can replace with an item like #Gzerk. Your local hardware store may have one too. You can…
view full answer...The Replacement Red Lens #A42RB should be the correct replacement lens for your Do Ray SS-105. Since this is a common style of light duplicated by several manufacturers. To verify this you can check the measurements of the light you have, if they are…
view full answer...We have 2-1/2 inch clearance lights but they require a 3 inch hole for the grommet like part #A55GB to install. For that you'd want the part #MCL51RB. The next size down is 2 inch but the hole required is 2-5/16 inch which wouldn't work for…
view full answer...Although we don't have a kit that includes the bearings/seal all in one package, you can certainly obtain the parts separately. You'll need: #25580 inner bearing and its #25520 race #LM67048 outer bearing and its #LM67010 race #21325 Double…
view full answer...I would use a protractor, see photo, place the protractor on the edge of the inside of one side of the trailer frame and the other inside edge of the trailer frame should be parallel with the 50 degree line on the protractor. Another way to verify…
view full answer...It looks like Trailer Hub and Drum Assembly - 5,200-lb Axles - 6 on 5-1/2 Item #8-201-5UC3 could be the right replacement for you. You can check the bearing numbers if you still have the bearings. If they are 25580 for the inner and LM67048 then this…
view full answer...Your fifth wheel rails with the CMI stamped on them were manufactured by Curt, and will be compatible with Curt, Draw-Tite, Husky, Reese, Valley, and other brand hitches. They fit what are called industry standard hitches. For your 2008 Ford F-350, I…
view full answer...The expert reply you were looking at is correct. The only way to confirm if your 2019 Acura RDX has the plus 12 volt power provision is by removing the interior trim and seeing if the factory connector has one or two red wires. I can completely…
view full answer...If the landing gear on your brand new Forest River Trailer is not working at all, either to extend or retract the legs, then most likely there is some kind of a power issue. I do recommend starting by making sure the battery is charged and in good…
view full answer...The Peterson Piranha LED 2-1/2 Inch Round Trailer Clearance Light, 3 Diode #162R light that you referenced is certainly a bright trailer light. This 3 diode LED light will be brighter than a standard trailer light for you. I have attached a review…
view full answer...Yes, it is possible. To get started you will need a hub and drum that matches the bearing and seal on your trailer spindle and your wheel bolt pattern. Confirm this by checking the bearing part number, and seal part number. Next, you will need left…
view full answer...Filter Your Search
Contact and Help