Search: e track rails   >  

Hey Eric, the MORryde RV TV Wall Mount part #MR57RR that you referenced only locks in the upright stored position but in the various lower positions the shocks will hold it at various heights without drifting. It also allows the TV to pivot from side…

E-track like the etrailer part #e42VR is made from 12 gauge steel which is 2.5 mm thick.

The capacity is 2,000 lbs per track for the etrailer Horizontal E-Track - Black Powder Coated Steel - 2,000 lbs - 94" Long #e42VR. The weight capacity is per track, so using two of them side-by-side will give you a 4,000 lb capacity. So yes it…

Not only can it be done it is actually much easier than you might think John. First for the battery you want to select a deep cycle battery like the #BRW34FR. This will need to be stored in a Box #DW03009 to protect it from the elements. You can…

I have attached a wiring diagram for the Ventline Remote Switch, #VC0533-03-A, that is used with the Ventline Ventadome Roof Vent with 12 Volt Fan #V2119-603-00.

The part number that was provided is actually for the screen, #BVD0434-31, which is included with some Ventline roof vents. To obtain the part number for the fan you will need to remove the screen. I have attached a set of installation instructions…

I have included a diagram that shows the location of some screws that attach the screen frame and the upper housing (fan shroud) to the flange. That may allow you to access the area you are needing to look at. The Ventline Northern Breeze is a…

The E-Track has slots that have a length of 2.45-inches and a width of .58 inches. See attached diagram.

E-tracks are typically the stronger of the two, but X-track is more versatile since you can mount them horizontally or vertically. Choosing between the two really depends upon how you plan to use them. If you are installing something in a truck bed,…

According to my research the CellTech trailers looked to have vertical etrack installed directly to the walls, but since you're trailer has the honeycomb paneling that isn't solid all the way through you'll need to install some studs to…

Hey David, yes the Pro Series jack part #PS1401460303 will work with the pipe mount part #e52JR as they are both 2 inch.

To install the Replacement I-Beam Jack Bracket #LC349975 for Lippert Ground Control 3.0 #LC358590 you'll need to follow the instructions that came with the Lippert Ground Control 3.0. I've attached a cutout from the instructions for the…