Videos
for Search Results
Help Articles
for Search Results
Expert Answers
for Search Results
According to the installation instructions from Dexter Axle the torque specs for the wet bolts on their Dexter E-Z Flex Suspension Kits, like part #K71-653-00, is 30 - 50 ft-lbs. I have attached a clip from their instructions for you to check out.
view full answer...Yes, the spring width would matter when using the Dexter Over Under kit part #K71-384-00 that you referenced. If you check out the picture I attached you'll see that if the spring was too wide the u-bolt holes of the plate wouldn't fit around…
view full answer...Hey Cody, you are installing this B&W Turnoverball #BWGNRK1020 on a 2021 Chevy 2500 correct? If so, the M14 bolts are definitely the correct size. It is possible that the holes in the frame are corroded which is preventing the bolts from…
view full answer...In order to confirm fit of the Electric Ground Control TT Automatic 5-Point Travel Trailer Leveling System part #LC672136 you'll need to review the installation instructions (attached below) and confirm fit yourself as there is no year, make, and…
view full answer...Yes, they do. The Firestone Ride-Rite Red Label Extreme Duty Air Helper Springs item #F95FV will fit the dually and single rear models of the 2024 Ford F-350 4WD. These air bags have a 7,500 lbs capacity that will level out the rear end of your F-350…
view full answer...The Air Lift LoadLifter 7500 XL Air Helper Springs part #AL86KV are what I recommend for a 2022 Ford F-350 DRW. This is a heavy duty kit with 7,500 lb rating that will be perfect for the constant load of a truck bed camper. It will help reduce sag as…
view full answer...If you were to use the 4 inch offset ball #BWGNXA4085 the pin weight on the ball will not be changed. What will change is where the weight is carried on the truck. Using the offset ball will put more weight 4 inches back from the center of the…
view full answer...We have the TorkLift Cannon Hitch Extension for 3" Ford Super Duty Factory Hitch #TLE1642. You will not be able to use an extension of this length with a rise hitch adapter. This is because the 42" hitch extender has to be secured with…
view full answer...We do have 6-Pole Square Trailer Wiring Connector Kit (Car and Trailer Ends) #37995 that you can use for your Arctic Fox camper. This is both the male and female ends. But the wires on them are 18 gauge. You could replace the ground and power wires…
view full answer...The fan of the MaxxAir MaxxFan Trailer Roof Vent w/ 12V Fan - w/ Rain Cover #MA00-06200K draws 5 amps. In theory a 750 amp battery would power this for 150 hours.
view full answer...For your LED Marker Light RV Side Cameras w/ Night Vision for Furrion Vision S Systems #FOS05TASF you will want to follow the wiring as provided below: RED: Connects to positive wire on running lights circuit. BROWN: Will connect to the positive wire…
view full answer...The Valterra Wheel Chock #A10-0908 doesn't have a weight capacity since it isn't really designed to hold the weight of a vehicle - it's just meant to keep a wheel from rolling.
view full answer...Filter Your Search
Contact and Help