I don't have any specifics on your boat or trailer but the main thing you need to check before using the CE Smith Bunkboard Guide-On Kit part #CE27600K75 is your frame size. This kit works with trailer frames 3" wide and up to 4-1/2"…
The CE Smith Side Angle Mounting Brackets for Boat Trailer Rollers - Galvanized Steel - 1 Pair #CE10211G have holes that are 2-1/4 inches on center and 1-1/4 inches on center in the other direction. I've attached a photo to assist as well as a…
That is really odd! Especially if its only one brake magnet. I would assume that there is a short from the camper battery positive wire circuit to the brake output but even that should affect all of the brake magnets. I would start by testing to see…
We do have a Bearing Buddy which fits a similar dimension as the 2-3/4" you referenced but I do recommend using a digital caliper and measuring your hub bore size to the thousandths of an inch to ensure you get the correct fit. For a 2-3/4"…
This Submersible LED Trailer Light Kit with 25 foot Wiring Harness, part #TLL9RK, uses all stainless steel mounting hardware. The mounting hardware of this trailer light kit should work well in the saltwater conditions that you use your boat in.
I went out to the warehouse and pulled a CE Smith Stake Pocket, #CE45004G, to take some measurements. The dimensions listed on the product page are correct. The opening is 3-1/2 inches wide by 1-1/2 inches deep. A lumber industry standard 2x4…
Curt recommends the use of 250 ft/lbs of torque when tightening the nuts of their hitch balls with a 1 inch diameter shank like the part #C40034 that you referenced. The general rule is for a 3/4" shank tighten to 150 ft/lbs For a 1" shank…
Filters
