Videos
for Search Results
Help Articles
for Search Results
Expert Answers
for Search Results
Yes, we do offer the correct replacement lens for the LED Trailer Clearance or Side Marker Light with Reflex Reflector part #328-K-59LB as part #CE84VR.
view full answer...I went out to the warehouse and measured a T-Handle Locking Stainless Steel Flush Door Latch, #L4080. The overall depth is 2-3/4 inches. The latch on the back side is adjustable and will fit on a door that is a 1-3/8 inches thick to 1-11/16 inches…
view full answer...According to my Redline representative, all of the #L4080 T-Handle locks are keyed alike. I have confirmed this myself by pulling a few of them off the shelf in the warehouse. They all use the same key number, so if you order four of them, they…
view full answer...The Trailer King RST are a pretty middle of the road tire, not bad but not a top of the line tire. On the other hand the Kenda Loadstar ST tires are a high quality tire designed and strenuously tested in Ohio to make sure the tires are as reliable,…
view full answer...No, you wouldn't weld the bar to the mounting brackets for the universal cam-door lock, #383200. The bar needs to be able to rotate and welding it would prevent it from moving. Only the handle would be welded to the pipe. I have included a…
view full answer...Since you have an older trailer, the brakes could have possibly been switched from electric to hydraulic or the other way around. Even on newer campers, unless it is just purchased from the manufacturer, it would be just a guessing game for someone…
view full answer...I believe you're looking for the Kodiak Hydraulic Brake Hose - 3/16" Male Fittings w/ Stainless Flares - 1/8" ID - 20' #bh-3mfs-20. At this length I assume that you're wanting to run this hose the length of the trailer so I do…
view full answer...If you mount the Redline 2-Piece Polypropylene Trailer Vent #WHMAV2-WAVT2 with the exterior part's flat slotted side facing forward (to increase air flow) there will definitely be a greater probability for rain and splashed water to enter the…
view full answer...Yes, you can mount the Redline 2-Piece Roof Vent, #9139, on the front side of your cargo trailer. You will want to mount this vent with the vent slots facing down to prevent rain water or other elements from getting into the trailer. If you are…
view full answer...There many possible ways to mount a stabilizer jack such as the #TJ01RT-HD you looked at. Mounting them in the orientation shown the diagram would tend to work a bit better to stabilize the trailer against side to side movement, while having the…
view full answer...The Ultimate Trailer Jack part #322-RDJ-2K is the lowest profile trailer jack and would work great for you. Since the bracket is adjustable you can set the height of the jack at a very low height as needed.
view full answer...The a-frame trailer jacks all use a standard mounting pattern and center hole size for the most part so although I am not quite sure what you are measuring I can confirm we have options, the Ultimate Trailer Jack part #322-RDJ-2K is a good one…
view full answer...Filter Your Search
Contact and Help