Does a 3/4 Inch Pipe Get Welded to the Upper and Lower Brackets of Universal Cam-Door Lock
Published 02/06/2015
Question:
Does the top and bottom bracket that goes into the 3/4inch pipe get welded to the 3/4inch pipe
asked by: Rich
0
Expert Reply:
No, you wouldn't weld the bar to the mounting brackets for the universal cam-door lock, # 383200. The bar needs to be able to rotate and welding it would prevent it from moving. Only the handle would be welded to the pipe. I have included a link to a video review of this part for you.
expert reply by:
Michael H
0
Product Page this Question was Asked From
Cam-Action Lockable Door Latch for Small Trailers and Trucks - Zinc Plated Steel
- Trailer Door Latch
- Reversible
- Cam-Action Latch
- Lock Not Included
- Bolt-On
- Zinc-Plated Steel
- Polar Hardware
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Q&A: Does Advent Air RV AC Unit Use Wall Mounted Thermostat or Remote Thermostat
- Q&A: Recommended Handle Latch Kit for Barn Door on Dump Trailer
- Q&A: Can the A522VP Cam Locks Be Keyed Alike for a 2012 Ram Service Truck?
- Q&A: Replacement Jack Screw and Nut Kit for a 12K Bulldog Jack
- Q&A: Replacement Door Parts for Featherlite Trailer
- Q&A: Dimensions of Replacement Strike Plate for Bauer Products RV Door Locks
- Q&A: What Size Hardware Is Used To Install The Buyers Hitch Plate 3371809061A?
- Article: Holiday 2025 | RVers’ Favorite Gear & Road Picks
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: How to Tell the Weight Rating of a Trailer Axle
- Article: How to Replace an RV Roof Vent Cover
- Article: Slipper Spring Trailer Suspension System Review
- Article: Trailer Maintenance Schedule
- Article: Trailer Tire Sizing