Videos
for Search Results
Help Articles
for Search Results
Expert Answers
for Search Results
We do not have a seal that matches the inner and outer diameter you have provided. That being said, I believe the markings on the seal actually indicate that your ID is 1.25" and our OD is 1.979". Your measurements are…
view full answer...We do have a compatible grease seal for your 168255TC oil seal, however, we do not carry rubber coated seals in this size. The 168255TC oil seal was designed to work with oil bath hubs on a 3,500 lb axle. For the most part, axle manufacturers have…
view full answer...The SuperSprings Custom Suspension Stabilizer and Sway Control Kit #SSA15MXKT will fit your 2004 Chevrolet Silverado 2500HD. These are designed to assist up to 2,600lbs of weight with trucks that have the leaf springs mounted above the axle. This…
view full answer...Yes, leaf springs must be replaced in pairs which is why one side left go and then the other shortly after. In regards to the stent you get on a full set of leaf springs, there are really a ton of variables present here so it is hard to predict.…
view full answer...We sure can! The Transcom #TCM 21344 TB cross references to the 10-10 seal we offer, part #RG06-090. The seal has a 2.125 inch ID and a 3.376 OD. It's compatible with a 25580 inner bearing.
view full answer...I reached out to my contact at firestone to confirm a few things. If the compressor is running, it should be filling the bags. The compressor is either going to build air pressure, or not build pressure. So if it is running when the bags are full,…
view full answer...Currently we only carry the Replacement Compression Latch #313-8-325-281 as an assembly for the RC Manufacturing Z-Series Truck or Trailer Underbody Tool Box #UB1818-36. We will not have just a replacement key cylinder for the latch.
view full answer...A 16 inch tire will not fit on a 16.5 inch wheel. You would either need to get new 16 inch wheels with the proper bolt pattern to match what the hubs require or to get your existing wheels you would need to go with 16.5 inch tires. You mentioned…
view full answer...I looked up the information on your TDE 46205 Hubs and found a couple of great replacements for you. The one you pick will depend on the number of wheel studs you have. For 5 wheel studs use the etrailer Trailer Idler Hub Assembly for 2,000-lb E-Z…
view full answer...The correct wet bolt/ shackle upgrade kit for your MORryde CRE/3000 axle will depend on the length of your current shackle links, measured center hole to center hole. For 2-1/4 inch shackle links, use #MR46ZR or for 3-1/8 inch shackle links, use…
view full answer...I have a solution for you, but we do not have a double lip grease seal with the exact measurements you specified. However I was able to find out that the GS-1250 DL that you mentioned has the following measurements: Inside Diameter:…
view full answer...That is correct. The #GS-2250DL is the direct replacement for your old grease seal marked P02860 on your 2019 Keystone Cougar.
view full answer...Filter Your Search
Contact and Help