Search: 7 way trailer wiring kit   >   !Gooseneck and Fifth Wheel Adapters   >   Generators   >  

The axles we offer are available in 3 lengths. They are 60 inch, 72 inch, and 89 inches hub-face to hub-face, but I may have a solution for you. We do offer axle-less systems that are either bolted or welded to the trailer frame. This would replace…

Thanks for the picture of your trailer frame. Based on seeing them the Lippert Shock Kit part #LC281255 does fit since it's a boxed frame and you already verified that the axle diameter matches.

I do have a great option for you, however we do not have any standard 3,500 pound round tube axles available that match the dimensions you provided. For an exact replacement your best option will be to go through a local trailer shop or the…

The way to remove a riveted item on yoru trailer is by using a drill. You want to use a drill bit that is smaller than the head of the rivet. This will remove the body of the rivet and then you can just easily pop the head of the rivet out without…

Either way is correct. It depends on if you want to keep the semi-style 7-Way (if you need to tow that type of trailer) or if you will never be towing a semi-trailer. If you need to keep the 7-Way semi active on the truck, then you would need to make…

You certainly can! Installing a brake controller is fairly easy if you are familiar with running wiring. To install a brake controller like the popular Tekonsha Prodigy P3 #90195 you will need to run the wires on the pigtail to the following…

The trailer brakes work on a separate circuit than the lights. You have a couple of options to control the electric brakes on the trailer. One option is to use an air over electric brake control, #HA100400C. This unit connects to the air brakes on…

I have attached a photo for you below which shows how both a vehicle side and trailer side trailer connector is typically wired. I say typically because this is not always exact and so long as the trailer and vehicle side both match it will not…

You are correct that this refrigerator does not have an ON/OFF switch or function. The best you can do is "Standby" that draws an unknown amount of power. One option is to pull the 12-Volt fuse at the RV power center. A much better option…

Although we do not offer that exact replacement fan motor for the Everchill Refrigerators you can use Valterra FridgeCool Automatic Exhaust Fan Item #A10-2618VP which is a universal fit motor and will work with any refrigerator.

The bolt pattern of your Dexter axles for the mounting of the brake assemblies is a 5 bolt pattern like what the part #AKEBRK-6 has. If you wanted assemblies for both sides of your trailer this kit will work great. I attached a picture that shows the…

I currently have three diffrent self-adjusting assemblies for your boat trailer with 10" x 2-1/4" electric drum brakes which are attached for you below. eTrailer Electric Trailer Brake Kit part #AKEBRK-35-SA (3,500 Axles) Dexter…