What is 5 Bolt Pattern of Brake Assemblies for 12 inch Dexter Brake Assemblies
Updated 08/22/2017 | Published 08/21/2017
Question:
dexter axles,attern for plate mounting to axle, brake pads are 12 inch by 2 inch
asked by: Corky
0
Expert Reply:
The bolt pattern of your Dexter axles for the mounting of the brake assemblies is a 5 bolt pattern like what the part # AKEBRK-6 has. If you wanted assemblies for both sides of your trailer this kit will work great.
I attached a picture that shows the bolt pattern dimensions.
expert reply by:
Jameson C
0
click to enlarge
Product Page this Question was Asked From
etrailer Electric Trailer Brakes - 12" - Left/Right Hand Assemblies - 5,200 lbs to 7,000 lbs
- Trailer Brakes
- Electric Drum Brakes
- Standard Grade
- Manual Adjust
- 12 x 2 Inch Drum
- 5200 lbs Axle
- 6000 lbs Axle
- 7000 lbs Axle
- 14-1/2 Inch Wheel
- 15 Inch Wheel
- 16 Inch Wheel
- etrailer
more information >
Continue Researching
- Q&A: How to Add Timbren Axleless Suspenion to a Trailer and Use 5 x 5 Lug Jeep Wheels
- Article: Trailer Wiring Diagrams
- Article: Electric Trailer Brakes: How They Work & What to Buy
- Q&A: How Many Brakes Come With The etrailer Electric Trailer Brake Kit AKEBRK-6?
- Article: How to Tell the Weight Rating of a Trailer Axle
- Q&A: Instructions to Wire a Trailer for Electric Brakes
- Q&A: How to Measure For Replacement Slipper Spring Equalizer For Gooseneck Trailer
- Q&A: Comparing Dexter and etrailer.com 7,000 Pound Electric Brake Assemblies
- Q&A: How To Measure Wet Bolts And Suspension Components On Tandem Axle RV
- Q&A: Replacement Hub/Drums And Electric Brakes for a 5200 lbs Axle
- Article: Most Popular Wheel Bearings
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Replacing the Bearing, Races and Seals on a Trailer Hub
- Article: How to Adjust Your Trailer Brakes | The Ultimate Guide