Search: 56473   >  

It's pretty simple. A 4-bolt rail uses four 5/8 inch bolts ran through the floor of the truck bed into the frame brackets. The bolts run down through the center of the raised part of the rail, as shown in the photo I provided. A 10-bolt rail…

We actually have a version of the #ETBC7 that we put together specifically with the Curt Echo Mobile brake controller part #C51180 in mind with the #ETBC7L which comes with just the components needed for the Echo. The ETBC7 comes with the same…

A 155/12 tire will be about 6.1 inches wide. The closest match is a 145/12 at 5.7 inches wide. I have included a link to all of the tires and tire/wheel combos we have in this size. A 155 isn't a trailer tire size (unless it has an ST in front of…

The Draw-Tite Trailer Hitch item #DT42GR does not require any wiring to install on your 2023 Jeep Grand Cherokee. It is custom fit and bolts to your Jeep with included hardware. This is a class III hitch with a 2" receiver that has a 7,500 lbs…

I have attached for you below some common torque values needed for a trailer suspension system but a lot of these will vary by bolt size and other factors. U-Bolts: Varies by Size - 1/2" bolts: 45 ft/lbs - 70 ft/lbs, 9/16" bolts: 65 ft/lbs…

In addition to making sure the pilot hole of your wheel is large enough you will also need to measure the bolt pattern of your wheel (see FAQ and video). The bolt pattern of the Dexter Trailer Hub and Drum #8-201-5UC3-EZ is 6 on 5-1/2. I contacted…

Yes we do have the Curt Class III hitch part #C55WR that fits your 2021 Mercedes Benz GLA. This is a 2 inch hitch with a 3,500 lb trailer towing capacity.

We have not yet had the opportunity to install the Curt Trailer Hitch Receiver #C55WR on a 2021 Mercedes-Benz GLA. This hitch does have a bolt-on installation, and the heat shield must be modified or trimmed. Although we do not yet have an…

The ZCI Circuit Protected Vehicle Wiring Harness #119250KIT will give you a 4-way flat connector on your 2023 Jeep Grand Cherokee Limited. This will allow you to install the sensor over the wiring for the tail lights rather than splicing into them.…

The specs listed for the #KDBC225DAC Kodiak caliper I found online match up with those of the Reliable CL-1000. Either would be compatible with a 3500 to 6000 lb axle but because it hasn't been officially tested, If I were in your shoes I'd…

Based on my research, the Kodiak Disc Brake Caliper #KDBC225DAC should work perfectly as a replacement for the existing Reliable CL-1000 Calipers on your trailer. This hasn't been officially tested by the manufacturer but based on the specs they…