Search: oval reverse light > RV Light Fixtures > Command Electronics x > LED Light x >
Videos
for Search Results
Help Articles
for Search Results
Expert Answers
for Search Results
When using the 4-Leaf Double-Eye Spring for 4,000-lb Trailer Axles part #e27SR with the Single-Axle Trailer Hanger Kit for Double-Eye Springs part #APS4 you will need to space the leaf spring hangers 25-3/4" apart.
view full answer...Behind the emergency brake pedal on the 2015 Chevy Suburban mounted on the floor will be a black plastic cover that covers an electric junction box. If you remove the cover you will be able to plug in a brake controller install harness like the part…
view full answer...Excellent idea, switching to LED. They use less power, last much longer and are brighter than incandescent lamps of the same size. Win, win, win. The grommet mount lamps you reference should fit in a 6-3/4 by 2-1/2 inch rough opening, which is the…
view full answer...The light dimensions of the Optronics LED #TLL12RK are 7-9/16" long x 2-3/4" tall x 1-3/4" deep and the hole size needed is 6.75" by 2.5 inches. I confirmed this with my contact at the manufacturer and I've attached a template…
view full answer...We have 6-1/2 x 2 inch lights but the wires and grommets are sold separately. I recommend the the Trailer Tail Light - Stop, Tail, Turn - LED - Waterproof - 10 Diodes - Red Lens #STL72RB along with the 3-Wire Pigtail for Optronics Trailer Lights -…
view full answer...The Optronics Fleet LED Trailer Tail Lights w/ Grommets #TLL12RK will fit perfectly in the opening you measured on your trailer. Replacement trailer lights can be confusing at times because each manufacturer uses slightly different dimensions so the…
view full answer...Due to the age of your 1995 Ford F-150 there currently are no plug-an-play type options available, but we do offer the 7-Way Pre-Wired Car Connector, 7' Lead #20023 which can hard wire into vehicle's trailer wiring harness. I've attached…
view full answer...I have a solution for you but all of our axles are underslung so you won't find one with the bracket on top. To install the Dexter Trailer Axle Beam with E-Z Lube Spindles item #8327816 you will need the Dexter Trailer Springs Over-Under…
view full answer...Square axles can be tough to determine capacity. Often times the same spindle fits a range of axle capacities. The best way to determine the capacity is to get the inner and outer bearing numbers stamped into the metal of the bearings like you did.…
view full answer...The best way to confirm the weight capacity of your Dexter Torsion Axles is to find the lot number on the axle tag which is located on the center of the axle on the rear side. This tag should say Dexter Axle and then a 9 digit number. The number you…
view full answer...There isn't a great way to identify the weight capacity of a torsion axle by the size. The only true way to determine capacity if an axle tag is not present would be to pull the hubs and measure the spindle or read the part numbers on the…
view full answer...The 2x2 inch square axle is likely 3,500 lbs or less capacity. I would need more spindle dimensions or bearing numbers to assist. If you pull a hub and measure at the spindle where the bearings and seal ride using the digital caliper like #PTW80157 I…
view full answer...Filters
- 8 results
Vehicle Fit
Filters
