Search: command electronics trailer lights > RV Camera System > Rear x > Standard View x >
Videos
for Search Results
Help Articles
for Search Results
Expert Answers
for Search Results
I do have an option for you but we do not carry any Mor/Ryde products so I would not have any replacement parts if that is what you are looking for. If there are components that are rusted or corroded then it would be best to just replace the entire…
view full answer...The correct replacement transfer switch for your PD52 transfer switch in your 2019 Jayco North Point, is the: - Progressive Dynamics Transfer Switch - Metal Case #PD52. This transfer switch can automatically reroute your RV's AC input from shore…
view full answer...Hey Carla! Sorry to hear about your fireplace. We're not going to have an identical replacement. Our closest option is going to be a bit smaller so you'd need to make a few modifications. It is the Greystone 40" Electric RV Fireplace…
view full answer...The closest Go Power option to the Magnum Energy MM1212 Inverter Charger is the Go Power Industrial Pure Sine Wave Inverter Charger #34280055. This inverter/charger is rated for 2000 watts running and 4,000 watts surge/startup. This equals out to…
view full answer...The Replacement Amber Lens for Peterson Oval Clearance and Side Marker Lights #108-15A looks to be a close match and it measures 3-3/4" long x 1-5/8" tall x 15/16" deep so it should work just fine.
view full answer...The Curt Spectrum Brake Controller #C51170 should illuminate, even if the trailer is not connected. If you are getting no lights at all, this likely means the control unit is mis wired, or there is contamination in the trailer plug socket. We…
view full answer...It sounds like the sensitivity needs to be adjusted on your Curt Spectrum #C51170 since it is too aggressive leading to the jumpy stop. To adjust the output and sensitivity you want to follow the instructions. This means you only make adjustments…
view full answer...Hi Shawn! I was able to find a little info on the Binkley 48000 SL you need to replace, and it looks like the etrailer Square Jack w/Handle - Foot Lever - Drop Leg - Spring Return - 12K Lift - 26.5" Travel #TJDDP-20000SP-F will be a pretty close…
view full answer...Hello Marcy, thanks for reaching out. We do have a good replacement option for you. Take a look at the Bulldog Square Jack #BD182804. This has a 27-3/8" retracted height and extends out to 39-1/2". It has a 10K lift capacity and 12K support…
view full answer...Hello Bill. The fact that the rear axle measures longer than the front is definitely concerning. Since both axles have the same part number and such, they should be identical in length. Trailer manufacturers do not make tandem axle trailers with two…
view full answer...Gas lines on RV's are typically 3/8" OD with a some being 1/2" OD so 3/4" pipe would likely be a bit overkill for your needs. The MB Sturgis Vertical 2-Stage Propane Regulator #108220 you referenced does have a 1/4" Female NPT…
view full answer...Tom, unfortunately the controller 2020003067 is not going to work in place of the 289252, so It would need to be replaced with the 289252. I have also confirmed this with Lippert to make sure.
view full answer...Filters
- 8 results
Vehicle Fit
Filters
