Does the Draw-Tite Max-Frame Trailer Hitch Interfere W/ Foot Sensors On a 2024 Honda Prologue
Does this block the foot sensors for the power rear liftgate operation? | Jon, our techs have not reported any issues with that feature so the Draw-Tite Max-Frame # DT38KV won't interfere. If by any chance they don't work traditionally, we've...
Is There Frame Drilling Required to Install Draw Tite Hitch # DT38KV
Does this hitch require drilling in the frame? | Hey Miks, there's no frame drilling required to install the Draw Tite hitch part # DT38KV. There is some trimming of the rear fascia but nothing too crazy at all. What are you planning on using...
Is 2024 Honda Prologue Limited to Listed 150 lb Tongue Weight with Draw-Tite Hitch Installed?
Hi - looking at the Drawtite hitch for the Honda Prologue, the tongue weight limit is 350lb. Looking at the honda prologue specifications, it states a tongue weight limit of 150lb. Do you know if the lower limit on the Honda spec is a limit...
Will a 4.80-8 Trailer Tire Fit in Place of a 4.00-8 Tire
I have seed planter with implement tires of 4.00 x 8. Will a 4.80 tire fit? | Yes, a 4.80-8 tire will fit in place of a 4.00-8 tire. That is why a lot of times you will see both sizes in the product's title or description and even on the actual...
Does Draw Tite Hitch that Fits 2024 Honda Prologue Have Better Ground Clearance Than OEM
Is there any information about how this hitch compares to the OEM hitch sold by Honda? Specifically, I’m wondering if there is a difference in heights from the ground between the two and if the rear trim piece sold by Honda would be compatible...
Do All Hitches for 2024 Honda Prologue Require Frame Hole Enlargement
Hello. I Hope you can help me. I’m looking to lease a 2024 Honda prologue and I need to install a trailer hitch to carry my mountain bike. I can drill into frame under lease. I read some of the comments and it appears the tie down holes need...
Why Choose a Powered Taillight Converter Over a Non-Powered Model
What dictates the need between using a powered Tail light convertor Vs a non powered? | There's a couple of factors that determine that. On older vehicles, very few vehicles needed a powered converter, because the vehicle's electrical system...
Which Kat's Block Heater Fits 2025 Mitsubishi Outlander SE 2.5 Liter
Will this heater work, without modification, on my 2025 Mitsubishi Outlander SE? Please confirm the location for this vehicle as well. | Hey James, yes the Kat's Heater part # KH11812 that you referenced is a confirmed fit for your 2025 Mitsubishi...
Troubleshooting Trailer Wiring When Connecting a 4 Flat Vehicle Side to 4 Flat-5 Wire Trailer
I have a 2001 Isuzu Rodeo and was recently trying to connect the connector wires to my trailer. My Rodeo is setup to use a 4 flat female end that runs to 4 wires Ground, Tail, L Turn, R Turn to a converter that connects the 4 wires of the end...
Trailer Hitch and Wiring for 2009 Mercedes R320 Diesel
I have a 2009 mb R320 diesel w251 . The information on the web site indicates the class 2 trailer hitch and separate wiring packages are for a r350 MB the wiring package is with brake controller and 7 way. Can to clarify the correct products...
Will The DT38KV Interfere With Kick Sensor On 2024 Honda Prologue?
I have a 2024 Honda Prologue Elite. I purchased the Draw Tite hitch model DT38KV. I have read the instructions and I do understand I have to trim an under carriage panel. My question is have you guys run into an issue with the tailgate sensor...
Will the Curt Hitch C89RV Block the Liftgate Sensor on a 2024 Honda Prologue?
Hello, I’m looking to install a hitch on my 2024 Honda Prologue. I have the Touring model. I have a question about C89RV. Does it interfere with the kick tailgate open function the vehicle has? Also, can you provide installation instructions?...
Recommended 4-Way Wiring Harness for a 2025 Honda Prologue
I have a 2025 Honda prologue. It does not have a factory wiring harness. I’d like to add a flat 4 wiring harness for the trailer lights. Can you give me the exact part number? I’m looking for from your site. Thank you. | Hey Tracy. The Curt...
Does Draw Tite Hitch DT38KV Stick Out Past Rear Bumper
After installation, what is the clearance under the hitch? Does it stick out past the bumper at all? Would mostly be using it for a bike rack and an occasional flat trailer for Home Depot runs. Not a deal breaker at all, but does it block...
Can a 3-Wire to 2-Wire Trailer Wiring Harness Converter be Bypassed
can i by-pass a 3 to 2 wire taillight converter in any way | The only way to bypass a 3-wire to 2-wire trailer wiring harness converter (assuming your vehicle has a 3-wire or separate tail light system) would be to convert your trailer to a...
Diagram of the Portion of the Fascia that Needs Trimmed to Install Curt Hitch # C13103
do you have a sketch of how much to trim do you cut around hitch support bar ? | I attached a copy of the installation instructions for the Curt hitch # C13103 which is confirmed your 2007 Mercedes R350. The installation instructions have...
Should Radial or Bias Tires be Used for a 3500lb GVWR Pop Up Camper Trailer
Vehicle - 2011 Coleman Sun Valley pop up camper. Fully loaded - 3500lbs I cant seem to figure out which tire to get. It seems there is much debate on trailer tires, whether to get radials or bias ply. My stock tires are Kenda ST185/80D13-D and...
Where is Connector Found on 2001 Isuzu Rodeo for Installing Hopkins Trailer Wiring Kit HM43215
I cannot see the plug you guys talk about in the jack compartment, however there is a similar plug on the bottom beside the spare tire is that the correct plug, and do I have to do any other connections? | The plug you have found is the correct...
Is Cutiing Required for Installation of the Mercedes-Benz R350 Trailer Hitch # C13103
I would like to know if there is any cutting of the oem bumper required in order to fit your trailer hitches? | You will not need to cut the OEM bumper for installation of the Curt Trailer Hitch, item # C13103, for the 2008 R350 by Mercedes-Benz....
4-Way Trailer Wiring Recommendation for 2002 Isuzu Rodeo
HI first Id like to thank you for you time to answer my question. Ok I have a 2002 Isuzu Rodeo and I want to install a 4way trailer conception. But I only see a connecter with 2 wires one hot and on ground I believe they are the running lights...
Trailer Hitch for a 2012 Mercedes R350 BlueTec
Will this hitch also fit the Mercedes 2012 R350 Blue Tech diesel model? Also, where is the best place to get the hitch installed once I buy it? I doubt that a dealer would do the work but I am afraid to trust non-Mercedes technicians, especially...
Removal of Fascia on Mercedes 2008 R350 When Installing a Curt Trailer Hitch, Part # C13103
Once I get the facia off, I can install the hitch. Any tips? Ive removed the 4 bolts under the rear bumper. How do I get the rest of the facia off? CURT 13103 model hitch. | I spoke with my contact at Curt and he informed me that the underbody...
Trailer hitch for a 2004 Isuzu Rodeo with 3.5 Liter Engine
my is 2004 rodeo 3.5 liters wish i will use | The only trailer hitch that will fit the 2004 Isuzu Rodeo with 3.5 liter motor is Curt hitch # C13235. But in order for this hitch to fit your Rodeo must have the rear door mounted spare tire. It...
Trailer Hitch and 4-Way Wiring Recommendation for 2018 Mitsubishi Eclipse Cross
I need a hitch and 4 wire harness for a 2018 mitsubishi eclipse cross | For your 2018 Mitsubishi Eclipse Cross we have the Curt hitch # C13273 which is a confirmed fit and then for 4-way wiring you'd want the part # C56296 and you'd be set. |
Filter Your Search
Contact and Help