!Eagle Super Lite Travel Trailer  x   >   !NX Turbo  x   >   !Rhino  x   >   Gorilla-Lift  x   >  

How would you go about weighing a tailgate to ensure you get the correct tailgate lift assist assembly? Also, is it necessary to have them on both sides of the tailgate? | The easiest method to weighing your trailer's tailgate would be to use...

How are the closed tubes attached to the trailer rails. I do not see any bolts exposed? Are there carriage bolts or what? | Each assembly that goes on one side of the trailer is actually two pieces, which gives you easy access to the mounting...

how long are the replacement cables for the gorilla tailgate lift | The entire cable to the end of each loop is about 57-1/4 inches. Between the clamps on each end before the loops is about 51-1/4 inches. The replacement cable for the Gorilla-Lift...

Trying to find end caps that will fit on the end of Gorilla lift trailer aid. OD is 2x2 ID is 1.75 will this 2x2 plug work. Thank you | The Replacement Square End Cap # 853-5826 should work perfectly for you. I went out and measured...

To much tension on the cables on my gorilla lift can’t pull gate down | It sounds like the tension on your Gorilla-Lift Utility Trailer Tailgate Lift Assist w/ Cable # GL1 is too high. To lower it, you're going to need to: 1.Lower the point...

77x12 Doolittle pipe top utility trailer with a 5foot fold flat ramp. Can the ram still be folded flat with gorilla lift installed? Are the cables easy enough to detach to do so? | For the Gorilla-Lift Utility Trailer Tailgate Lift Assist...

I have had this product for 4 years and have to replace the cables about once a year due to them breaking. Is this normal, if so, it is getting expensive | I would say that it is not normal to have to replace the Gorilla Lift cables with #...

i have a RAM 3000 lb support cap with 2000 lb lift cap jack ext 23" extended - retracted 9" - would like to known if it would be feasible to change to a bolt on swivel . What would you have lift assist for tailgate 46 H x 73 W 6-2 tubing...

Gorilla-Lift Utility Trailer Tailgate Lift Assist w/ Cable, will this for a 4x6 trailer | It is going to be the size of your 4' x 6' trailer's side rails and tailgate that matter when determining if the Gorilla-Lift Utility Trailer Tailgate...

Jameson C A while back you answered an inquiry as to a Gorilla Lift install on a bifold trailer ramp. I am looking to do the same install on a BiFold aluminum HD ramp and wondered if I could contact the customer that submitted the photo to...

My Gorilla-Lift Trailer Tailgate Assist is not lowering completely. Is there anything that I can do? It has worked all summer. | I did some research and here are some thing you can do if your Gorilla-Lift Utility Trailer Tailgate Lift Assist...

My heavy duty utility trailer side walls are 28 inches from the bed to the top of the angle iron and the gate is 50 inches from the hinge to the farthest point. The literature indicates up to 24 inch side walls for this product. Will this work...

Does anyone manufacture a tailgate LIFT assist? | We do carry tailgate lift assists for both trucks and for trailers. We have the Hopkins EasyLift Truck Bed Tailgate Lift Assist # 74211 that will fit most trucks. If you can confirm your year,...

The specs say for 12inch to 18inch sides , and in the qanda section say 10inch to 24inch sides ? Which is correct ? My sides to 24inch . Can i use this product ? Is there different install dimensions for a 24inch side install ? Thanks | I do...

Interested in Gorilla-Lift Utility Trailer Tailgate Lift Assist w/ Cable - 300 lbs Item # GL1 Have dual axle 6x16’ open Holmes trailer with split extra very heavy tailgates. Each side weights 60-70 pounds to lift. Will these help much? What...

Hi, what would be the trailer ramp assist that I would need for the Big Tex 70TV 7x16? The sides are a bit taller than most... 29inch 3/8 height I believe. | The best trailer tailgate/ramp assist we have for your Bix Tex 70TV Trailer is the...

All I have is new cables I dont have the new springs . Can you list in order how to replace the cable to the existing Springs for the assist tailgate. | There is a bolt and nut at the end of part # GL1 that holds the spring in place. When...

6 x 10 trailer to haul Polaris side by side what size gate lift should I get? | The right gate lift assist is really going to depend on the weight of the trailer gate so you'd need to know how much it weighs to determine the correct lift assist....

The top rail height on my trailer is 22.5 inches from trailer floor. Top of my tail gate is 49.5 inches from the floor. Will this work with this part? | I have a solution for you, but the Rack'em Double Barrel Utility Trailer Tailgate lift...

Will I need to remove the lift assist handle from the first section of the tailgate? The section that is closest to the trailer. | When using the Gorilla-Lift Utility Trailer Tailgate Lift Assist w/ Cable part # GL1 on a trailer with a split/hinged...

Doesnt the quick link make it 2 inches longer than the original cable? If so how do you adjust for that | The Replacement Cable with Quick Link for Gorilla Lift Utility Trailer Tailgate Lift # GLC1-Q1 comes with the quick links. I've attached...

Gorilla lift is this for one side ? or both sides? | The Gorilla-Lift Utility Trailer Tailgate Lift Assist w/ Cable # GL1 comes with 2 pieces, one for each side of your trailer to pull the gate up evenly. Both pieces combine for a 300lb capacity. |

Can I put a gorilla lift on 1 inch rail ? Trailer is a sure trac steel side | As long as the trailer side rail is between 12 and 24 inches in height and the tailgate is between 4 and 6 feet in length the Gorilla Lift # GL1 would fit and work...

How do I get the smaller spring attached without cutting the large spring off? The end of the smaller will not come out enough to clear the end of the big spring. | According to the instructions for the Gorilla-Lift Utility Trailer Tailgate...